Jump to content
SAU Community

Recommended Posts

was giving the car a boot load last nite and it did something it hasnt done before

changing from 1st to 2nd the car sort of shuddered, or dipped in power

before accelerating normally

it was quite violent

sort of half through you forward, and then powered up normally, all the way to redline in second gear

havent noticed it before

would that be a miss?

was almost all the way to redline in 1st, then gear change, dip/stall and then normal acceleration

was certainly cooler air around last nite

no weird readings on pfc hand controller

edit:

car is r33, stock turbo at 12psi, powerfc, hks exhaust cam gear, exhaust, dump pipe, usual mods

had new plugs put in 20000ks ago to get rid of a miss at higher than stock boost

Edited by Spook's_Skyline
Link to comment
https://www.sau.com.au/forums/topic/96695-a-miss/
Share on other sites

bump, no one seen anyhting like this before?

the dip happens getting on full throttle in second gear after changing into it

car holds up for a second, and then accelerates normally (and quickly and smoothly to redline again)

also have walbro fuel pump

Link to comment
https://www.sau.com.au/forums/topic/96695-a-miss/#findComment-1756782
Share on other sites

check the knock readings on the pfc.

did it ping as soon as you got into 2nd?

if so your map might be a bit lean going into hard gear changes when you stamp on the throttle changes for a split second.

If this is the case a bit more fuel will help at that particular address.

hope this helps :huh:

Link to comment
https://www.sau.com.au/forums/topic/96695-a-miss/#findComment-1757056
Share on other sites

i didnt get a tune before the cam gear pulley

but i got 192rwkw with what i have

how can i tell if its coil packs?

if im cruising in second at 40km/h and nail it, it accelerates smoothly all the way to redline

its only an issue when im full on it in first, and then to second

Link to comment
https://www.sau.com.au/forums/topic/96695-a-miss/#findComment-1757961
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
    • I checked spark on all cylinders and they all visually have spark with the plug pulled and grounded, but plug 1 is the only one that fouled. This was a running swap that blew up and was rebuilt by a machine shop, put a new wiring specialties harness and did all gaskets, studs, and bolts while it was out.  compression is 135-150 across all cylinders. Aside from that from my understanding with the z32 ecu and maf the car should start regardless. The wiring for TPS and the dual 02 sensor/ dual knock sensor stuff shouldn’t actually stop the car from starting or even running well, (just slightly rich)  they just give fault codes. Car supposedly is supposed to start as long as you have z32 afm and ecu with the nistune base map and that’s info coming from a well known and trusted tuner who does a lot with SR/RB (Rsenthalpy). After more trouble shooting today where I’m at right now is that the cas is sending signal to the injectors they click while spinning the rotor, Fuel pressure is now set at 43psi, all cylinders have good compression and all of the plugs looked great (just wet with fuel) except for cylinder 1 which was very black (cylinder 1 has 150psi compression). all of the coils generate spark if pulled out and grounded out on the head. On the fuel pump car just pops into the exhaust. On starting fluid car will fire off. Hard to tell if all cylinders are firing off but definitley a couple. sounds like all of them but it’s only for 3-5 seconds hard to tell. 
    • Final update!!! Got the front bar fitted and sprayed and all sorted now. My cutouts worked great and the indicators aren’t just falling off. 😂  
    • Is this a brand new LSD? if so, have you followed any break/bed in procedure for it? Usually involves heaps of figure 8 patterns, a fluid flush.
    • It's TWO steering wheels actually. 😛 one for each hand They are wheels, and they steer!
×
×
  • Create New...