Z24O

still up for grabs? were the compressions checked across the cylinders after the head gasket was done?

$100 for the xr6 comp housing

that's a pisser how much to rebuild them...i am looking at a secondhand set,so would like to now the possible full price!!!

has it still got the coil packs,manifold,plenum???....any idea of compression across the cylinders,did you run the motor in your car? what are you doing with your r34de motor?

got a mint series one,after $400 posted,no lines/dump but does have banjo fittings

as long as they aren't wannabes what offset?

what size housings (a/r)? journal bearing cores? of vg30det (x 2) or both off vg30dett ?> how much?

bump

sold

pretty sure this ones got an aluminium comp wheel located in perth

Garrett GT3782,run for 2 dyno pulls,as new see pics,large shaft,T4 flange .54 a/r compressor housing 1.12 a/r turbine housing 55lbs flow rated journal bearing but much better than old school TO4's as has garrett GT wheels(largely responsible for improvements in new garrett turbos rather than the fact they are ball bearing cores) also cheap to rebuild...best of both worlds $950

sold

sold

http://www.skylinesaustralia.com/forums/in...howtopic=165515

http://www.skylinesaustralia.com/forums/in...howtopic=165518

http://www.skylinesaustralia.com/forums/in...howtopic=165516

http://www.skylinesaustralia.com/forums/in...p;#entry3072846

E6A,little use,very robust electronics

apologies for the resurrection as well but i am looking to purchase a gtr that has had a front end collision with a high kerb....just under the intercooler....the impact has sheared off the 2 castor rods and pushed one wheel far enough back in the wheel arch to bend the trailing edge or the guard by about 2" now the $64 000 question......do you reckon this would have bent the chassis or is it likely to be repaired with bolt ins?? now i know you guys don't have a crystal ball,but i am looking for suggestions re the chances of chassis damage...likely,maybe,definately,unlikely,etc am i likely to be able to verify anything visually if i jack it up and take a decent butchers or am i wasting my time looking?? cheers guys

beleive this guy left for canada on the 10th according to his other thread

got a haltec if you're interested in a swap...maybe even cash you're way?

will the cam gear fit an rb30 sohc?

does it have the 3" adapter with it? how many km's use? any damage/contamination?

....presume it's viscous?? if its mechanical pm me your bank details and i'll dd $100 to cover purchase and postage

need more info as requested.......posted above