Jump to content
SAU Community

Recommended Posts

fuji motorsport in lansvale, syd have a white v spec with hks hyper d sus and 18' deepdish enkeis for 26kono

Edited by krayzie32

Hey

In response to all the PMs requesting a compression test well I just had it done at GT AUTO newmarket.

Compression was read at the 6th crank on each cylinder:

145

145

145

145

145

143

Engine has been replaced not long ago to an N1 and is running strong!!

Cheers

M

can you get better photos of the interior, like the dash and carpets? also can you post a photo of the conplete VIN number plate to prove its a vspec?

cheers

Edited by ookami

Pics coming.

I tracked the VIN back to the original owner and car came with brembos etc from new. Car also has factory oil cooler, finned rear diff, etc so definitely vspec.

M

can you get better photos of the interior, like the dash and carpets? also can you post a photo of the conplete VIN number plate to prove its a vspec?

cheers

Pics coming.

I tracked the VIN back to the original owner and car came with brembos etc from new. Car also has factory oil cooler, finned rear diff, etc so definitely vspec.

M

Don't mean to be picky, but R32 V-Spec don't have a finned diff from the factory.

  • 2 months later...
Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • There's restrictor pills in the stock boost control hoses. That's how they set the amount that was bled off and hence the "high" boost setting. The usual mod in the day was to remove it and send the "high" boost setting up to about 14 psi.
    • Thanks Duncan, that's the best info I've read. Furthermore after learning about the PCM programming side controlling the factory boost solenoid, the purpose of the solenoid is to "bleed" boost when pin 25 is earthed, thus allowing spring pressure in the wastegate actuator to overcome diaphragm boost pressure, thus closing or reducing the position of the wastegate flap creating more boost as the turbo is able to spin faster. It's pretty cool to see a designated Pill to do exactly this, would have liked to have seen it with a tiny filter over the end for those moments in vacuum.  The constant bleed pill has now been removed completely from the system and solenoid boost control has been restored once again.   Case closed 😂
    • The wideband reading is meaningless if it's not running. Why are you using shitty old sidefeeds on any engine, let alone a Neo? What manifold and fuel rail are you using to achieve that? Beyond that, can't help you with AEM stuff as I've never been their ECU/CAS combo.
    • Manual boost controllers (where a little of the boost was bled off) were quite common back in the day, because they were cheap and easy. Generally they had a manual adjustment screw rather than being fixed like yours. Down side is they always bleed boost, not just when you want them to so an electronic boost controller that uses a solenoid will have less lag.
    • Hello , im new here and i have A31 home build  RB25det neo stock eng / turbo  aem ems 2 blue connector  aem 3.5 map aem cas disk aem wideband connected to ecu  355 lph pump 550 nismo yellow injectors side feed aftermarket regulator  and won’t start with base aem tuner basic tune eventually flipped cas 180 degree so it triggers on correct stroke not in exhaust cycle  Now it won’t start Wideband reads 10 and 11 at lowest fuel setting  and will share calibrations soon for aem tuner i think something is wrong in aem tuner    please if you have any information, am very grateful         
×
×
  • Create New...