Jump to content
SAU Community

Recommended Posts

when people are saying 400 k's to a tank, is that 400k's till your fuel light comes on? or 400k's all up?

My fuel light comes on at ~400k's, but there is still 10L left once that happens, so theoretically I could get another 80 or so k's

  • Replies 77
  • Created
  • Last Reply

Top Posters In This Topic

The best way I have found to gauge fuel consumption is, fill the tank full, reset the odo, run it till almost empty (doesn't have to be when the lights on), when refilling next look at how many litres you need to get back to full then check how many ks you've done. That would be the most accurate way to say how many ks you get per litre.

Same here, as Erin, for a few dollars versus pushing the car or walking along the highway. I'll think I'll pay the extra money to be inside cruising along with the A/C on. But I'm lucky to get 300kay/tank

i get about 400 to ~48litres, i've never run it till the light comes on

however since my mercury tune i've been blowing more smoke than a woodstock festival and people who drive behind me complain of stinging eyes

also i get loud backfires from shifting from 1st to 2nd and 2nd to 3rd about half the time

however i just give whoever i just scared a wink like i meant it

I get those figures - seems 350-400ks per tank depending on the amount of city/highway driving. A/F ratos are perfect on the last dyno run i did (only about a month ago).

I think theres a few people on here that pull the 500k figures out of their probervials. Maybe i'm wrong (which i'll readily admit), or maybe their cars run dangerously lean.

I also remember reading an article in HPI where they guy that used to own a soarer that writes in the mag (maybe martin donnon??) was talking about the issue of warming up your car for 5 mins vs just turning the key and driving straight off. Concensus was it was waaaay better for fuel econ to just drive off as the car runs rich as when cold. Hence it was better to go Maybe its relevant in this case- like a temp sensor or even a thermostat problem -car is colder or at least thinks its colder than it is so runs rich for a longer period.

Oh i too get the fuel smell from time to time, no leaks i could find either.

Another point would be the issue of atmo bov vs plumback. Maybe thats causing problems too???

i think we should

i love my car, but its sending me broke

i need some money back

ps i still use the stock bov

my fuel economy seems to have gone out the window with my fmic install

also got a forward facing plenum with ford throttle body at the same time

i think we should

i love my car, but its sending me broke

i need some money back

ps i still use the stock bov

my fuel economy seems to have gone out the window with my fmic install

also got a forward facing plenum with ford throttle body at the same time

lol must be the ford tb then, is it carved from stone :P

Seriously tho i too would welcome any help that can be offered.

Well my a/rs are spot on 12, its almost a straight line. And no joke I got 530kms BEFORE my fuel light came on the other day (90%highway driving) and then it was 610kms before I filled up. Keeping in mind I have a heavier car than most of you, and a smaller engine, which should mean more load and more fuel used.

So, dont mean to be harsh, but for some of you maybe its your driving style?

But I do belive spooks and 53xyn really have a problem.

yup, my afrs are almost spot on 12 as well

doesnt seem to matter if i put around on low boost not boosting

or drive around on high boost not not boosting

perhaps a bit of highway running gets me slighter better returns, but id be lucky to see 400ks from a tank (nearly got 400 driving back from stanthorpe)

also, my charcoal cannister was also unhooked when i had the fmic/plennum done

hence the original post

im going to get my cannister hooked up again anyway, just to see if it makes a diff;

Edited by Spook's_Skyline

My GT-T at the moment is getting just under 400kms per tank (55L) and I think that's pretty bad :( I'm keen on knowing if there is a quick and simple solution to this...

I've noticed that the bigger turbo has helped improve it a bit (especially in the city) due to the lag. Not on boost as often :P

But yes, quick and inexpensive fix - bring it on!

I challenge anyone to take up my offer.

I will come out (you pay for fuel and it must be in brisbane) and if I can't fix the problem or tell you what the problem is...you don't pay me. Anyone getting 400k's or more can bugger off coz you aint got problems cept the right foot.

Edited by 3lit3 32
My GT-T at the moment is getting just under 400kms per tank (55L) and I think that's pretty bad :(  I'm keen on knowing if there is a quick and simple solution to this...

I've noticed that the bigger turbo has helped improve it a bit (especially in the city) due to the lag.  Not on boost as often :P

But yes, quick and inexpensive fix - bring it on!

Stan,

GTTs have a 65L fuel tank, so you should get another 100Ks plus minus. I get close to 600Ks on mine B)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Hi,  Just joined the forum so I could share my "fix" of this problem. Might be of use to someone. Had the same hunting at idle issue on my V36 with VQ35HR engine after swapping the engine because the original one got overheated.  While changing the engine I made the mistake of cleaning the throttle bodies and tried all the tricks i could find to do a throttle relearn with no luck. Gave in and took it to a shop and they couldn't sort it. Then took it to my local Nissan dealership and they couldn't get it to idle properly. They said I'd need to replace the throttle bodies and the ecu probably costing more than the car is worth. So I had the idea of replacing the carbon I cleaned out with a thin layer of super glue and it's back to normal idle now. Bit rough but saved the car from the wreckers 🤣
    • After my last update, I went ahead with cleaning and restoring the entire fuel system. This included removing the tank and cleaning it with the Beyond Balistics solution, power washing it multiple times, drying it thoroughly, rinsing with IPA, drying again with heat gun and compressed air. Also, cleaning out the lines, fuel rail, and replacing the fuel pump with an OEM-style one. During the cleaning process, I replaced several hoses - including the breather hose on the fuel tank, which turned out to be the cause of the earlier fuel leak. This is what the old fuel filter looked like: Fuel tank before cleaning: Dirty Fuel Tank.mp4   Fuel tank after cleaning (some staining remains): Clean Fuel Tank.mp4 Both the OEM 270cc and new DeatschWerks 550cc injectors were cleaned professionally by a shop. Before reassembling everything, I tested the fuel flow by running the pump output into a container at the fuel filter location - flow looked good. I then fitted the new fuel filter and reassembled the rest of the system. Fuel Flow Test.mp4 Test 1 - 550cc injectors Ran the new fuel pump with its supplied diagonal strainer (different from OEM’s flat strainer) and my 550cc injectors using the same resized-injector map I had successfully used before. At first, it idled roughly and stalled when I applied throttle. Checked the spark plugs and found that they were fouled with carbon (likely from the earlier overly rich running when the injectors were clogged). After cleaning the plugs, the car started fine. However, it would only idle for 30–60 seconds before stalling, and while driving it would feel like a “fuel cut” after a few seconds - though it wouldn’t fully stall. Test 2 – Strainer swap Suspecting the diagonal strainer might not be reaching the tank bottom, I swapped it for the original flat strainer and filled the tank with ~45L of fuel. The issue persisted exactly the same. Test 3 – OEM injectors To eliminate tuning variables, I reinstalled the OEM 270cc injectors and reverted to the original map. Cleaned the spark plugs again just in-case. The stalling and “fuel cut” still remained.   At this stage, I suspect an intermittent power or connection fault at the fuel pump hanger, caused during the cleaning process. This has led me to look into getting Frenchy’s fuel hanger and replacing the unit entirely. TL;DR: Cleaned and restored the fuel system (tank, lines, rail, pump). Tested 550cc injectors with the same resized-injector map as before, but the car stalls at idle and experiences what feels like “fuel cut” after a few seconds of driving. Swapped back to OEM injectors with original map to rule out tuning, but the issue persists. Now suspecting an intermittent power or connection fault at the fuel pump hanger, possibly cause by the cleaning process.  
    • For race cars, this is one part where I find having the roll cage bar having gone through a hole in the floor better than the build it up on a ledge inside... The Merc I help on, the main hoop ends are marked on the car, and the jack is marked... Jack goes under a few inches and lifts one whole side of the car up... Removes that fight for long slim jacks for race car duties!   My biggest issue for the daily drivers I work on, is my jacks don't go high enough. The jacks start out on a few blocks, jack it up, then start a second jack under it on more blocks, and then I can get an axle stand under it. My axle stands are presently in use, and are nearly fully extended. The car is sitting with barely more than a cm of clearance to get the wheel off the studs! Sarah's Kluger is the same, as it has an ungodly amount of droop available in the suspension and a distinct lack of good jacking points!
    • Happy? Yep, my to do list is getting shorter and shorter. Either this light approaching is the end of the tunnel, or I'm about to be hit by a train... Ha ha ha   Also, Duncan isn't that far out of town that you need to make a multi day drive out of it. 😛
×
×
  • Create New...