Jump to content
SAU Community

Recommended Posts

Hi all

Looking at getting an Apexi SAFC to improve fueling and hence fuel economy?

My GTT is rather stock except for a turbo back, and would like to get some extra kms or power out of the thing.

No plans for high boost, 10psi would be my maximum. No plans for huge mods (not even a FMIC) so no real point getting an expensive PFC.

With a stock setup, and if I keep the boost the same, will I see any gain in either power or fuel economy?

Or does this thing only really apply for a higher boost setup? ie. at 10psi will it be worthwhile?

If anyone has ever used a SAFC on their car, let me know your experience and what you guys think of it.

Thanks

Link to comment
https://www.sau.com.au/forums/topic/106045-effectiveness-of-a-safc/
Share on other sites

you wont get much better fuel economy.

while off boost and in closed loop mode, your A:F ratio's are probably close as possible to 14:1.

when you get on the gas, then it gets richer and richer.

so in standard form it might get to about 10:1.

an SAFC or any air flow meter signal bender for that matter, will only make an adjustment at full throttle type position.

so you can adjust that 10:1 to about 12:1.

pick up a hand full of KW's while your at it and the the car will use less fuel (JUST) when it is on full throttle.

I doubt you will actually save any money though, considering the car will have more power and be more fun to drive, you will be up it more often.

I had an SAFC on my S14.

it gained about 11rwkw on the same boost just by getting the mixtures to 12:1.

fuel consumption was still the same.

if you are not going to mod the car i wouldnt worry about it. upping the boost a bit might cause it to run a little richer though. I guess easiest thing is do the mods that you want chuck it on the dyno and see what the afr's are like. If they are really rich then buy one if not dont worry.

well I pulled 230rwkw out of my R33 witha safc2 and now I am after new kw target.

A very good unit and easy to wire into the car. well my cars fuel usage was the same as before but got a heap more power out of her.

selling my SAFC2 very soon so if interested drop me a PM mate!

you wont get much better fuel economy.

while off boost and in closed loop mode, your A:F ratio's are probably close as possible to 14:1.

when you get on the gas, then it gets richer and richer.

so in standard form it might get to about 10:1.

an SAFC or any air flow meter signal bender for that matter, will only make an adjustment at full throttle type position.

so you can adjust that 10:1 to about 12:1.

pick up a hand full of KW's while your at it and the the car will use less fuel (JUST) when it is on full throttle.

I doubt you will actually save any money though, considering the car will have more power and be more fun to drive, you will be up it more often.

I had an SAFC on my S14.

it gained about 11rwkw on the same boost just by getting the mixtures to 12:1.

fuel consumption was still the same.

Actually the SAFC has a high and low throttle map so the low throttle map can be tuned for max economy while the high throttle map can be tuned for power

I love my SAFC in my automatic 4wd Stagea.... plus have it tuned with a duel-stage EBC (10/12psi) and a SITC.

Had the SAFC tuned as a standalone unit at 10psi and had 140awkw with cat-back exhaust and stock R34 GTT intercooler (and with a new O2 sensor made an extra 150kms per tank)..... added the SITC, dump pipe and fmic and now have 160awk at 12psi still getting 400kms per tank before reserve (was 250kms originally).

If youve got an auto Id highly recommend it. But Id also recommend grabbing a SITC as well for the ignition timing alterations, as well as the air/fuel that the SAFC helps you tune.......

With my combo Id expect over 200awkw with a highflow turbo at mild boost.

I love my SAFC in my automatic 4wd Stagea.... plus have it tuned with a duel-stage EBC (10/12psi) and a SITC.

That's all well and good but not many stores sell the SITC?

EBAY!!! You can find everything on ebay. Search via worldwide (Super ITC, SITC, etc) - they come up fairly regularly, but I was lucky enough to find a BRAND NEW IN BOX unit!!

And only paid $220US for it as well including shipping from USA to Adelaide, whereas 2ndhand units sell for near the same price.

Now trying to save for a hiflow with GT30 internals..... but havent found one on ebay as yet, lol

  • 1 month later...

Hey Guys,

Definately a lot to read about and learn.

Obviously different things work for R32, 33 34 etc.

I have an R34 GTT 4 door. Has anyone had much experience in what works here?

What gadgets are best fit for better performance and consumption from airflow to boost controllers etc.. or all in one units?

Cheers,

Paul.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Even more fun, leave all the ADAS stuff plugged in, but in different locations, hopefully avoid any codes!   And honestly, all these new cars with their weird electronics. Pull all the electronics out Duncan, and just shove an aftermarket ECU and if needed a trans controller in, along with a PDM. Make it run basic but race car styled!
    • To follow up a question from earlier too since I had the front bar off again (fking!) This is what is between the bumper and the drivers side wheel And this is the navigator side, only one thing but its a biggy! So basically....no putting coolers in the wheel arches without a lot of moving other stuff. Assuming I move to properly race prepping this car I'll take that job on and see how the computers respond to removing a whole bunch of ADAS modules
    • So I prepped the car for another track day on Wednesday (will be interesting to see coolant temps post flushing out and the larger reservoir, with a forecast of 3-14 being 20o cooler than last time I took it out). Couple of things to mention; since I am just driving the car and not taking a support vehicle, I took the rear seats out and just loaded the back up Team Trackday style. Look at all that space! To cover off removing the rear seat....it is weird (note the hybrid is probably different because it wouldn't have folding rear seats) Basically, you remove the lower seat base, very similar to a r series but it is a clip that pulls forward to release the base rather than it being bolted down. Easy Then, you need to remove the side section of the rear seat on each side. There is a 14mm head nut at the bottom of the side piece, the it slides upwards off a hook at the top to release; you also need to unhook the seatbelt from the loop at the top. Then the centre piece is weird. You need to release/fold the seats forward with the tab in the boot on each side From there, there are 2,x12mm headed bolts holding the rear of each seat to the folding bracket, under the trim between the rear seat and the boot (4x christmas tree clips there, they suck). The seat is out but you can see where the bolts attach to the bracket
    • As discussed in the previous post, the bushes in the 110 needed replacing. I took this opportunity to replace the castor bushes, the front lower control arm, lower the car and get the alignment dialled in with new tyres. I took it down to Alignment Motorsports on the GC to get this work done and also get more out of the Shockworks as I felt like I wasn't getting the full use out of them.  To cut a very long story short, it ended up being the case the passenger side castor arm wouldn't accept the brand new bush as the sleeve had worn badly enough to the point you could push the new bush in by hand and completely through. Trying a pair of TRD bushes didn't fix the issue either (I had originally gone with Hardrace bushes). We needed to urgently source another castor arm, and thankfully this was sourced and the guys at the shop worked on my car until 7pm on a Saturday to get everything done. The car rides a lot nicer now with the suspension dialled in properly. Lowered the car a little as well to suit the lower profile front tyres, and just bring the car down generally. Eternally thankful for the guys down at the shop to get the car sorted, we both pulled big favours from our contacts to get it done on the Saturday.  Also plugged in the new Stedi foglights into the S15, and even from a quick test in the garage I'm keen to see how they look out on the road. I had some concerns about the length of the LED body and whether it'd fit in the foglight housing but it's fine.  I've got a small window coming up next month where I'll likely get a little paint work done on the 110 to remove the rear wing, add a boot wing and roof wing, get the side skirt fixed up and colour match the little panel on the tail lights so that I can install some badges that I've kept in storage. I'm also tempted to put in a new pair of headlights on the 110.  Until then, here's some more pictures from Easter this year. 
    • I would put a fuel pressure gauge between the filter and the fuel rail, see if it's maintaining good fuel pressure at idle going up to the point when it stalls. Do you see any strange behavior in commanded fuel leading up to the point when it stalls? You might have to start going through the service manual and doing a long list of sensor tests if it's not the fuel system for whatever reason.
×
×
  • Create New...