Jump to content
SAU Community

Recommended Posts

I have padded 6 point roll cage for sale with bolts. Execellent condition open to reasonable offers.

Price $1100

Reply via pm, this thread or email [email protected]

Edited by zaffa
Link to comment
https://www.sau.com.au/forums/topic/108125-padded-r33-7-point-cage/
Share on other sites

yes i've always measure point by how many places it bolts to/is welded to the car. BUT cusco/safety 21 cages are measure by the bolt points, and the rear bars, or maybe the just count the number of bars. so your would be a 7 point in their lingo either way. add the bar that runs straight across the bottom and they call it an 8 point.

is this for one with a sunroof or no sunroof, i guess the interior needs to be removed to fit it?

ben...

I am unsure about the sunroof but i assume it would fit as the front crossover bar is right towards the front and i dont think it would interfer with a sunroof. And no the interior does not have to come out, however the rear cross bar needs to be removed to seat passengers in the back seat. And doesnt affect dash at all...

yes i've always measure point by how many places it bolts to/is welded to the car. BUT cusco/safety 21 cages are measure by the bolt points, and the rear bars, or maybe the just count the number of bars. so your would be a 7 point in their lingo either way. add the bar that runs straight across the bottom and they call it an 8 point.

Yes there is no lower bar on this cage so you could call it a 6 or 7 point cage. Comes with all mounting bolts would like to sell asap to finishes repairs on skyline...thankyou

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...