Match Porting Your Gtr Head

[fatz]

yea so the head joint said 1800 to get the head fully check

lol

any tips

for the beginner

im justgiong to have a thrash and grind out the black bits to match port it

lol

then its only 100 bux to get the ead service

yea baby

oh yea it must be worth 400 rwkw

watch out buster

[Cubes]

Bl4ck32 and I did our manifolds.

Grab a dremel and grind away.

The heads were spot on, I assume they were done by the head reco ppls that did a full rebuild, mild port/polish, valve deshroud for $1100 inc vrs gasket kit, the heads were done at the same time to save a little in setup costs.

The inlet/exh ports were hardly ported, more so cleaned up to improve flow around the vale stem guides, bowl etc.. I don't know a whole lot about head work but what was done we were told was the best bang for buck, the next lot of fiddlings would cost money (obviously lol) and offer bugger all improvement in flow.

The work was done by Chris Milton Engineering in Adelaide.

[thommo]

what about using the sandblasting technique...?

[fatz]

hopefully gets some picks up when i have a crack

im going to follow the black edges and hope for the best

pete

[Cubes]

I tidied up the gasket against the head then slapped the gasket onthe manifold drew the area with black texta that needed to be ground away and grabbed the dremel.