Jump to content
SAU Community

Recommended Posts

my car has bad picked up a pinging when it goes past 4500RPM

I use BP ultimate in it, i have had it to a local workshop who had it all day and said it will have to go back when they can figure out what is causing it

They believe if anything it may be an aftermarket 02 sensor that isn't working with the standard ECU, anyone got any other ideas what may be happening as it started it out of the blue one day while driving to work.

Link to comment
https://www.sau.com.au/forums/topic/119787-pinging-at-4500rpm/
Share on other sites

nah i haven't done anything to it yet. As far as i was concerned when i bought it, it was all stock standard except the HKS airfilter now i find out it has a aftermarket turbo dump and oxygen sensor. they checked all the mixtures and said that they were all correct

could be a bad batch of fuel. try some good octane boost like nulon pro strength. if that solves it then wait and see if it still does it on the next tank of fuel. if it still does it then get it looked it, if it doesn't come back even after a few more tanks of fuel then it was just a bad batch. and make sure you don't put too much octane boost in as it can actually lower the octane.

mate of mine is a mechanic and he had the nulon rep come through work and he was asking him about the octane boost. the rep had an octane tester with him so they did some tests. at 50% strength it went by only about 2ron, at full strenght it went up by 6ron, and at double strength it dropped by 4ron.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
×
×
  • Create New...