Jump to content
SAU Community

Recommended Posts

Sorry you guys might be thinking this question has been answered a million times before.

But im asking because i need certain body parts for my car

I recently got into a car accident. Nothing major really.

Damages were mainly rims, body and the last thing i cant really figure out.

My rear right wheel is on a slight angle at the moment... guessing lower control arms?

Anyways, just wanted to ask about the body differences of a r33 s2 (my car) to a s1.

What body parts i need are the front bar, left front guard and the rear left guard (if thats what you call it).

Everything else is minor scratches and dents... they can be fixed easily.

I was wondering with those parts, is it possible for me to get them of a series 1 r33?

Hoping they would fit.

Also any help with that rear wheel would be appreciated.

Thanks

oh ok... so i guess i should watchout what to buy

Yea i have a r33 s2 m-spec

does that mean i have to find the exact body parts for my car?

I plan to fit the car with a new Jun bodykit

thought having a s1 front guard wouldnt be too much of a difference

I thought the front guards were the same. The headlights and bonnet are the same. I thought the Series 2 had different front bar & different wing, not sure about side skirts.

I would think that panels for an R33 Skyline should fit series 1 or 2.

Edited by Quinny

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hopefully it ends up being something manageable, like a hone, rather than a full bore—it would be a huge relief if it’s not as bad as it looks. Hang in there; these setbacks are annoying, but it sounds like you’re handling it as smartly as possible.
    • At the end of the day, it’s all about understanding the odds and being comfortable with the potential cost, whether it’s horsepower on a build or chips on a roulette table. And I have to say, the Laine example made me laugh—some people really do embrace that carefree, “roll and see” attitude!
    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
    • https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
×
×
  • Create New...