Jump to content
SAU Community

Recommended Posts

post-10809-1151148531.jpgpost-10809-1151148449.jpgHi guys

I am thinking of selling my r32gtst 4 door auto, yeah i know the auto is not too appealing.

Its in good condition needs minor work done and the paint is in fair condition.tinted windows ect

Wanting to sell due to the purchase of a new car.

$7000 firm rego till jan 2007 Drives well

please pm or reply will get back asap

Edited by da_line
Link to comment
https://www.sau.com.au/forums/topic/123558-eoi-r32gtst-4-door/
Share on other sites

where are you located mate?

how much k's, what needs to be done to the car?

ITS done just over 170.000 k just on the clock

but the whole motor was replaced just over 12 months ago, from genesis before they closed.

i am in the eastern suburbs of melbourne.

It needs a little bit of front end work done, just maintenance things that i cant afford at the moment with two other cars, brake,s bushes ect nothing major

post-10809-1151205802.jpg

Edited by da_line
  • 2 weeks later...
  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.    
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...