Jump to content
SAU Community

Recommended Posts

For some suspension engineering work, I need a number of sets of front and rear strut tops for R32/33/34 Skylines and Stageas. Make no difference whether they are GTR, GTST or GTS4, 2 door or 4 door, Series 1 or Series 2.

I need the COMPLETE strut top assembly. That means the metal strut top itself, plus the top and bottom rubber mounts, the rubber spring mount and the top cup washer. I don’t need the bump stop, dust cover or the nut that goes on top of the shock shaft. Refer to the following picture.

Rear_Spring_Seat_Top.jpg

If you have changed to aftermarket coil overs, then 99% of the time these items will not have been used.

I will pay a reasonable price for them, including costs of packing plus I will arrange for them to be picked up via courier. Please PM me for details.

:teehee: cheers :P

Link to comment
https://www.sau.com.au/forums/topic/127925-standard-r323334-stagea-strut-tops/
Share on other sites

  • 2 weeks later...

Still need 3 sets, anyone who has fitted a Jap coil over kit will have the standard strut tops left over. I will put them to good use.

:) cheers :woot:

  • 4 weeks later...

Still need a couple of sets particularly R32GTR, R32GTS4 and R32GTST rear strut tops. I will pay the going rate for them.

:O Cheers :)

Edited by Sydneykid
  • 2 weeks later...
i have 4 pairs of complete r32 gtst front struts here... if you take all 4 pairs ill do them for 50/pair plus postage

PM sent

>_< cheers :happy:

  • 2 months later...
  • 2 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I thought it could be an issue because the standard plate was flexing when stressed. Maybe the original gear set will hold a bit better without flex? Last time on the dyno it made around 670nm at the hubs. Now it have bigger turbo and better intake but have not been on a dyno yet. The car is being used from family trips to drag race events. So the shifts can be a little violent. It is grinding if I shift to fast so was thinking I should overhaul it soon.
    • From the factory on RB26s there's a fitting on the intake manifold collector/"plenum" that provides pre-throttle boost signal. That's how they did it back in the day, I figure it's fine to replicate it.
    • I would be surprised if that wasn't the issue. It's probably telling you, that even if you remove the plastic liner, you may have some other clearance issues that may occur too in some scenarios. IE, tyre to guard. It looks like someone has already rolled the lip, but you may still have issues in the future IE, turning and hitting a bump etc. The fact it changes how bad it makes the noise when you are going backward vs forward is highly indicative that it's the tyre rubbing. They do make a terrible sound, even if you're only pushing a project car that has a liner hanging down on a tyre!   Has the car been lowered? If it has been, what is the measurement from the centre of the wheel hub to the lip of the guard straight up?
    • Summernats cruiser?
    • Mark's a bit smarter than people give him credit... He'd convince the person that is to become dead, to drive him to the forest first. That way his car has no evidence in it, and he's free to dispose of their vehicle permanently how he sees fit too...
×
×
  • Create New...