Jump to content
SAU Community

Genuine Tommy Kaira M25 (r33 Gts-t 5-speeds Turbo)

R32 Autech
 Share

Recommended Posts

R32 Autech Collaborator

R32 Autech

Posted
Posted (edited)

Here is the one of the Best R33 Gts-t (5-Speeds Turbo), whole car modifly by Leading Japanese Tuning Company (TOMMY KAIRA)

It have Tommy Kaira intercooler, Tower Brace, 18 inches mags and nuts, Exhaust, Suspension, Full body kit with signature and also a Certificate Plate inside the engine bay.

Also I put Blitz Power Meter, Apexi Boost Controller, 2-Stage pager alarm system, Pionner MP-3 Head Unit and 7500K HID System.

The reason why I selling my baby is need bigger car and relative coming from oversea!!

Car only done 49000km (Genuine, it have 36276km when it was import at 10/2005 with document provide)

It only have a few in the country maybe less than 5 in total!!

Asking $21,200 nego

Inspection and test drive are most welcome

Interest call 0433347376

post-26782-1157360089.jpg

post-26782-1157360161.jpg

post-26782-1157360227.jpg

post-26782-1157360284.jpg

post-26782-1157360317.jpg

post-26782-1157360394.jpg

post-26782-1157360443.jpg

post-26782-1157360489.jpg

post-26782-1157360555.jpg

post-26782-1157360611.jpg

post-26782-1157360685.jpg

Edited by R32 Autech
Blitz Grand Master

Blitz

Posted
Posted

You have 3 engines for sale, various new parts, freshly imported cars and you are wrecking another vehicle.

Sounds to me like you are a trader, and as such you must pay to advertise parts on SAU

Edit: Further inspection reveals that you are selling parts on this forum under multiple account names, both of which were registered on the same day, using Yahoo Hong Kong email addresses (R32 Autech and enr34)

Do not open another thread in the for sale section, or you will be banned.

Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • The Bogan
      NC MX5

      By The Bogan · Posted

      The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Komdotkom
      R32 Gtst - Track Car

      By Komdotkom · Posted

      Good luck on the weekend mate
    • Duncan
      From Japan and back to Europe, my sh*tbox R34 GTT

      By Duncan · Posted

      Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Duncan
      New

      By Duncan · Posted

      Welcome to SAU, what are you looking at buying?
    • GabsReDeal
      R32 GTS (RB20DE) Injectors Replacement

      By GabsReDeal · Posted

      I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...