Jump to content
SAU Community

Recommended Posts

with a supercharger, you actually lose power to make power and are less efficient that turbocharging which uses the exhaust gas

and correct me if im wrong but the v350 is a v6, so in theory it is best to have a turbo for each bank of the vee ( $$$ ), so a supercharger is probably better as you only need one as it runs of the crankshaft ( off the engine )

for superchargers id check out www.capa.com.au

or for turbos www.airpowersystems.com.au/

Edited by beerbaron
Link to comment
https://www.sau.com.au/forums/topic/143372-sc-vs-tc/#findComment-2673831
Share on other sites

Any FI kit that fits the 350Z will pretty much fit the V35 (not sure about the 3.0L engines). There are minor differences, but if you go turbo it generally replaces those bits anyway....namely the intake tube.

Most of the TT kits I've seen make 260-300rwkW. The big ones are Power Enterprise, APS and GReddy (although Jim Wolf Technology has released one recently). Of the three, the APS is the most complete and its the only one that's ADR approved. Its not cheap, though, and in Australia can only be fitted by an APS approved dealer.

I know of at least one APS TT on a 350Z in Perth. The owner had their car shipped to Melbourne for APS to install before shipping it back, but since APS no longer does retail work I'm not sure what options you'll have.

Supercharger-wise, the HKS Rotrex unit is quite solid. You're looking at around 225rwkW with a catback. Do a full exhaust on it, and you'll probably see a bit more.

Vortech also does a centrifugal supercharger kit for the 350Z, which CAPA sells in Australia. That's rated at 210rwkW, but its possible there's no intercooler in that setup (the "quality features" is a bit ambiguous).

There are other supercharger kits, but they're generally US companies and not well supported down here.

Link to comment
https://www.sau.com.au/forums/topic/143372-sc-vs-tc/#findComment-2689068
Share on other sites

with a supercharger, you actually lose power to make power and are less efficient that turbocharging which uses the exhaust gas

and correct me if im wrong but the v350 is a v6, so in theory it is best to have a turbo for each bank of the vee ( $$$ ), so a supercharger is probably better as you only need one as it runs of the crankshaft ( off the engine )

for superchargers id check out www.capa.com.au

or for turbos www.airpowersystems.com.au/

Technically you lose power on both. Its just that a turbocharger has less loss than a supercharger.

There are single turbo kits available for the VQ35DE, but most are like the APS kit in delivering power in a big "hump". They also delete the factory's twin cats and run test pipes, which means if you get EPA'ed you'll get shafted.

Since most of the catbacks for the V35 are twins, which means you'll need a custom exhaust anyway. There's a guy in Sydney looking at doing a single turbo on his 350Z, and will add a 4" cat himself into a custom single pipe exhaust.

Supercharging will be far more cost effective. The kits are cheaper, its less invasive, and can practically be done with hand tools. And you won't need to upgrade the support systems the kit doesn't replace. The OEM clutch will not handle the 280rwkW a TT kit makes. The viscous LSD may also not have the strength required to provide the traction you need. Its also a pain trying to find room for an oil cooler.

While you don't make anywhere near the power with the supercharger (most of them run 3-4psi), there's still enough power to make you clearly faster than a NA car. There's not so much power that it overwhelms the chassis, which is a good thing. You can write off 1st and 2nd in the dry if you're hard on the throttle on OEM sized tyres with a TT kit, and 3rd in the wet. The APS TT owners I know run a minimum of 275 width rears, and a few of them use Comp-R's on the street.

(Note: Most of my experience is with the 350Z, but since the Z33 and V35 are almost identical most of this information is still applicable.)

Link to comment
https://www.sau.com.au/forums/topic/143372-sc-vs-tc/#findComment-2689078
Share on other sites

In both systems, there is no point saying "they draw power" because the net gain is always higher power than the aspirated engine would have. As far as what is the better system for efficiency and power, the turbos win hands down. After overcoming the initial inertia of the rotating assembly low in the rev range and getting into its more efficient operating zones, the turbocharger is exemplary in harnessing what would otherwise be the considerable wasted thermal energy in the exhaust. Consider big trucks for a moment- they need to be as efficient as possible at the required power level....and they all use turbos. Also look at the Horsepower Heros comp- dominated by twin-turbo V8s these days.

Link to comment
https://www.sau.com.au/forums/topic/143372-sc-vs-tc/#findComment-2689220
Share on other sites

The other thing is that most modern supercharger kits tend to use centrifugal superchargers, for packaging reasons, which are inherently flawed in their design.

They use a turbine compressor (instead of a positive displacement like the screw type etc blowers) attached to a belt, which means it has all the flaws of a turbo relative to a supercharger, and all the flaws of a supercharger relative to turbos.

That said, I'm still debating with myself whether I want to run the HKS Rotrex supercharger kit (for all its inefficiencies) and aim for around 240rwkW (which should keep the car "usable" in the lower gears) or just pull my finger out and get twin turbos on my car. 280rwkW+ is a bit too much for me, I think.

Edited by scathing
Link to comment
https://www.sau.com.au/forums/topic/143372-sc-vs-tc/#findComment-2696179
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • I dunno about that as a blanket statement. Pitwork is Nissan's "Nissan genuine" thing, and for stuff like timing belts, I have found them to be excellent. Of course, for things like oil filters, you always use proper trusted brands anyway, not whatever the OEM has taken to using.
    • Ahhhh... If you were putting 12V to the led in there, that's likely made it very unhappy. Chances are how you put power, was 12V across an LED that's meant to only have about 20mA through it at peak, and a forward voltage of about 1.8 to 2.4 volts. That circuit is likely only a 3V3 circuit, and will have a resistor in series with the led too. That's my guesstimate on that light, without having touched one.
    • Another vote for installing them and see how you go.  I mean, you already own them, why would you not fit them? 
    • I have had too many of those over the years, my cars have a toolkit or at minimum a cheapy multi tool thing because its too easy to be snookered by some stupid plastic clip that stops you checking the battery terminal isn't loose.
    • Basically, if there is a part# on the nissan catalogue, it is a genuine part. There is a thing called "new old stock" which is stuff made years ago but never sold (or landfilled), but it is super hit and miss what you can buy. Other than some expensive Nismo stuff there is nothing new being made that suits these cars. The only time to be a little careful is (mostly in the US I think, but maybe Japan too), Nissan started rebranding some cheap crap maintenance parts like oil filters as "Pitworks"; stay away from them, if you are buying cheap just buy whatever the local car parts shop carries The three part numbers have an explanation on Amayama: 0V005 is auto, base style 0V015 is manual 0V505 is auto, hectic momo branded ones, maximum F&F points there!
×
×
  • Create New...