Jump to content
SAU Community

Recommended Posts

hrrrmmmm....

I ran a search for "Codes" and it came up with 4 pages. Went through each but couldnt find any accept for the ECCS.

GTRsean

Please send, or better post here so other noobs like me can find it easier when hitting the search button! :spank:

Found my post on fault codes by typing "fault" and "gtrsean" in member name

Here it is from my post:

People are always asking about faults with their steering, AWD etc so I'm posting up some of the codes from the manual to help with troubleshooting. Hope this helps:

Heres the codes for the common faults in the R32 GTR (not sure but may be similar to R32GTST)confused.gif

Codes are taken by counting flashes off EXHAUST GAS TEMP dash light for engine codes after computer is put into diagnostic mode(pop the interior fuse lid off and short the two top RH pins on the 14 PIN plug for approx 2 secs then open. Helps to just hook up a push button switch to the pins).

ATTESSA system taken off red light on computer under rear parcel shelf LHS when ignition is turned on

HICAS diagnostics need to be run with consult tool as there is no fault codes available.

Engine stuff:

CODE NO:

11. crank angle sensor signal system

12. Air flow meter signal system

13. Engine temp sensor signal system

21. Ignition signal system

34. Detonation sensor signal system

41. Intake temp sensor signal system

43. Throttle sensor signal system

Last but not least, the one we all prefer:

55. NO ERROR

4WD CODES:

LED FLASHES

1. Right front wheel speed sensor or circuit

2. Left front.........

3. Right rear........

4. Left rear.........

5. ABS right front wheel actuator solenoid or circuit

6. ABS left front.......

7. ABS REAR wheel.......

8. ABS actuator motor, motor relay or circuit

9. ABS actuator relay or circuit

10. ETS control unit power supply or circuit

11. Fore aft G sensor 1 or circuit

12. Fore aft G sensr 2 or circuit

13. Fore aft G sensor 1, Fore aft G sensr 2

14. G sensor power supply 1

15. G sensor power supply 2

16. Lateral G sensor or circuit

17. Air bleed connector or circuit

18. ETS pressure switch or circuit

19. ETS motor, motor relay or circuit.

20. ETS solenoid or circuit

21. THROTTLE sensor or circuit

22. ETS oil level switch or circuit

23-

24 or continually ON or OFF: ETS control unit, ground or ciruit.

--------------------

GTRSEAN

Excellente!

LoL, i had typed in "fault" when searching but it come up with quite a few results as nearly every thread here is about a "fault" :P

Thanx heaps tho!

Something for the search engine:

attessa

diagnostic

diagnose

fault

complete

codes

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • It is a kunfine Android screen . Does anyone know the wirering diagram of the fuga ??
    • just an update to this, poor man pays twice  Tried sanding down the pulleys but it didnt do the trick. Chucked another second hand alternator in the na car which I got for free off my mate and its fixed the squelling. Must have been unlucky with the bearings.    As for my turbo car, I managed to pick up a cwc rb alternator conversion bracket + LS alternator for 250 off marketplace, looked to be in really good nick. Installed it , started the car and its not charging the battery.... ( Im not good with auto elec stuff so im not sure if this was all I needed to do but I verified such by using a multimeter on the battery when the engine was running and I was only getting 12.2v )   I had to modify the earth strap for the new LS alternator , factory earth strap was a 10mm bolt which did not fit the bolt on the LS alternator which was double the size so I cut it off , went to repco bought some ring terminals that fit, crimped it onto the old earth strap and bolted it up to the alternator , started the car and same issue. Ran like shit and was reading 12.2 at the battery.  For a "plug and play" advertised kit thats not very plug and play but alas.  My question is , am I missing something ? Ive been reading that some people recommend upgrading the stock 80 amp alternator fuse to a 140 amp but I dont see how that would stop the alternator charging especially at idle not under load.  Regardless ive pulled it out and am going to get it bench tested by an auto elec tomorrow but it would be handy to know if ive missed something silly or have done something wrong.   
    • My wild guess is that you have popped off an intake pipe....check all of the hoses between the turbo and the throttle for splits or loose clamps.
    • Awesome, thanks for sharing!
    • To provide more specific help, more information is needed. What Android screen? What is its wiring diagram? Does the car's wiring have power at any required BAT and ACC wires, and is the loom's earth good?
×
×
  • Create New...