amnash

How did you go about connecting the bulb plug? Did you cut a large hole in the back of the plastic housing ? Did you seal it somehow?

Hey just want to say thanks for making this thread and keeping the photos alive. Doing this exact retrofit now and this has expedited the process. ✌️

I'll take your turbo, check your message box.

anyone running one? is it laggy?

ok thanks, what exhaust housing better suits the rb25? ive heard the gtrs is a bit laggy and given that has a 0.64 housing, the 0.73 kinugawa would be even worse..?? are most rb25 guys running the 8cm housing?

looking to upgrade the turbo on my neo. has anyone used Kinugawa turbos? this turbo in the link has the closest specs to the HKS GTRS turbo with a slightly bigger turbine. there's two housing options AR-0.57(8cm) or AR-0.73(10cm), the GTRS has a 0.64 housing. would the 0.57 housing be too restrictive or would it be ok with the larger turbine? dont know much about turbos, thanks. GTRS: compressor- 51.2 / 71.1... turbine- 47.0 / 53.8 ex housing- 0.64 Kinugawa: compressor- 52.5 / 68.0 turbine- 54.0 / 61.0 ex housing- 0.57 or 0.73 http://shopping.kinugawaturbo.com/kinugawaturbochargerbolt-on24inchesnissanskylinerb20detrb25dettd05h-16g8cm10cm-1-1.aspx

Just an update. I went with a stagea ecu they didn't have traction control so the codes are now gone. Just had Nistune board installed too but still factory tune for now.

Pics

looking to buy bumper brackets 62216-05U00(R/H) and 62217-05U00(L/H) to mount my intercooler. FAST says they are the same number for r32,r33,r34 gtr. there must be a gtr somewhere that is being parted out and wont be needing these.. this is the last piece for my factory fmic install on my gts puzzle, please help.

My friends Rb25 neo ecu is not sending spark signal for ‪#‎1coilpack‬ to fire.. tried another ecu and coil pack fires perfectly. What could of gone wrong with the ecu?fixable? Recent maintenance was spark plugs, didn't disconnect battery. Fried ecu?I've done my plugs many times without disconnecting battery..

anyone?? im sure someone has done this swap and had the same issues

trying to get the check engine light off in my r32. first off, the car runs fine, did a neo swap on my r32 and obviously didnt install the traction control system. I had originally bought a stagea ecu to avoid the code(stagea=no traction control) but i now have a mines r34 GTT ecu and the code is back. Basically i need to know how to trick the ecu in thinking the traction control is working. its code 46:Throttle motor Sensor signal circuit. theres four wires to the ecu that didnt get hooked up during the swap. Pin 51: Throttle motor Sensor Signal Pin53: Motor throttle switch Pin 37: throttle opening Signal Pin 79: ECM-TCM, TCS/ABS Integrated Control Signal(multiplex communication) can i connect two of these four wires? add a resistor somewhere? ground a wire? a big concern is frying my mines ecu so i dont want to just ground a wire and see what happens.. any ideas??

just had a sensor shaft snap after this mod. the pics arent working can someone explain the 180degrees out for the locator pin for me? i didnt do any of that and maybe thats why it snaped. i just pressed the cog on and installed.

whats the FSM page for this? i couldnt find it

anyone? if Linluv figures something out and shares my car might get fixed