Jump to content
SAU Community

Recommended Posts

Hi y'all

wasn't sure of the exact place for this...

but was wondering if this catback would fit my R34 coupe? It's apparently meant for a R33 GTS-T or GTR.

It's a HKS Super Drager.

I'm assuming it won't bolt on but will it be easy to modify to fit? Just get an exhaust place to do it?

cheers,

daniel

post-795-1167361601.jpg

Link to comment
https://www.sau.com.au/forums/topic/149075-will-this-catback-fit-my-r34-coupe/
Share on other sites

i brought a hks progressive/hi power exhaust meant for a r34 and tried to put it on a r33 and it didnt fit but only cost $50 to get it changed,

so i'd say its not going to fit, but cheap enough to fix

i was highly doubting it would fit, but if it's cheap enough to fix, that's more than good enough for me.

would still like some more opinions if possible before going through and buying it. I can get this pretty much asap, and i'm keen to. But always good to learn as much as possible first, to try and avoid major dramas = $$

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...