Jump to content
SAU Community

Recommended Posts

I had a C's short shifter in mine and it cost over $300 from memory. Not too hard to fit yourself, Prank had a step by step instalation with pix on here, not sure if its still here though, I just got my mate whos good with shit like this to fit, it wasn't a drama.

Link to comment
https://www.sau.com.au/forums/topic/149082-r33-gts-t/#findComment-2782371
Share on other sites

i'll 2nd ebay :)

I was bidding on a few that went for just over 100, but I missed out, still bidding though :dry:

Haysey - were they easy to fit yourself??

mine didnt come with any instructions and i put the bits around the wrong way and it kept jumping out of gears, but after searching and finding pranks tutorial i managed to get it right.... farken easy as, remove old loose one, put nice fresh one in, couple of hiccups but nothing major...

Link to comment
https://www.sau.com.au/forums/topic/149082-r33-gts-t/#findComment-2782631
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...