Jump to content
SAU Community

Recommended Posts

hi there

still hunting around for towbars, considering the max ones, but would need to get it fitted in SA.

I also went into a reputable tow bar workshop today. Quoted 495 for a custom heavy duty tow bar fitted... BUT they cannot fit H/D to my car as it was a large fuel tank and cant run tow bar stuff to one side of the chassis rails for strength/integrity. the could do the basic one for $395fitted which i dont want as i cant tow a car with that!

So - if i was to get a max towbar, and took it somewhere in SA - would they say 'we cant fit this and dont recommend etc etc etc...

Who has got a h/duty towbar in SA and where did you go???

thanks

-Matt

Link to comment
https://www.sau.com.au/forums/topic/151255-towbars/
Share on other sites

Tried to fit it myself but slight grinding and drilling required. Did not have tools at the time so got it fitted somewhere else.

Overall, nothing major and if i had had a grinder/right tools at the time, I could have done it.

Afterall, we are all but mere mortals.

Link to comment
https://www.sau.com.au/forums/topic/151255-towbars/#findComment-2821820
Share on other sites

I had my Max towbar installed by a workshop in sydney. Design of the towbar is great and nice and strong

Fitting was a real PITA, my car has a rear spoiler extension which made it much harder and the measurements were not quite right so some adjustments required. Also needed to modify exhaust mounts to ensure the muffler didn't hit.

But the bar itself seems to be the goods, I need to tow heavy cars so I needed it as strong as possible

Link to comment
https://www.sau.com.au/forums/topic/151255-towbars/#findComment-2828561
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Surely, just about any shop that has done a Skyline (or Supra, or RX-7, or EVO, or WRX) will have done E85. But perhaps you need to specify what type of car, what type of engine, what ECU, you propose to be using.
    • Try an oil additive. There's a couple of options for "easier shifting". These are essentially a similar idea to what Redline put into their Shockproof gear oils. I had a 2nd hand R33 (in fact, as of right now, it is still in the car) that simply would not engage any gear with the engine running, with normal gear oil in it. We dropped that and replaced it with Shockproof lightweight, and suddenly the gear lever did what it was supposed to. At a cost, of course, of the then ongoing damage to internals done by running Shockproof. But the synchros were already totally uninterested in life, so there was no loss.
    • It always ends with the car burning down.
    • I see what you posted, but how could a warning light be going on and off if there is no sender for it?  The only other explanation is that the wire that used to go to the sender from the warning light is earthing somehow in the loom or at the connector, or that you have connected the warning light wire to something (maybe the temp sender?).  
    • The original pressure sender (switch) had the standard connector and the temp sender had the single terminal connector also. The pressure switch is gone and those wires eliminated from the harness.  I left the temp wire as I too used the temp sender to plug the extra hole. I was hoping for an easy answer but I guess I'm going to need to trace some wires to see where my ghost oil pressure light voltage is coming from or maybe I'll just pull the bulb out as there's no pressure switch any longer.
×
×
  • Create New...