Jump to content
SAU Community

Recommended Posts

Ok, i'm Seriously thinking about a respray for my R33 (It's black). It only has very minor dents

and some kind of paint reaction on the roof. I'm going to get a few quotes today. I

need to know roughfly how much this is going to cost me? just so i have a figure in mind.

Thanks , Kev

Edited by K_E_V_I_N
Link to comment
https://www.sau.com.au/forums/topic/151728-respray/
Share on other sites

respray will cost u anythin between $1500-3k for a basic job.

I'd advise u to spend a bit more and not go for the cheapest option cos after "2 aussie summers" u will have regreted goin for the cheaper option when ur painted is faded and starting to blister and u end up havin to spend the same amount or more again to rectify the paint defects.

mike

Link to comment
https://www.sau.com.au/forums/topic/151728-respray/#findComment-2825291
Share on other sites

respray will cost u anythin between $1500-3k for a basic job.

I'd advise u to spend a bit more and not go for the cheapest option cos after "2 aussie summers" u will have regreted goin for the cheaper option when ur painted is faded and starting to blister and u end up havin to spend the same amount or more again to rectify the paint defects.

mike

Yeah, good point. Went out to get some quotes........ and came back with a sub & Amp >_<

Link to comment
https://www.sau.com.au/forums/topic/151728-respray/#findComment-2825387
Share on other sites

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • There was a great one on Victoria Rd in Gladesville too back in the day. I can only assume GTSBoy is thinking of the mill up on the wollondilly, no restaurant there any more but they have restored the original steam engine on site and run it every few months, have an annual steampunk festival etc @The Bogan, you came to the wrong town for restaurants. we have a few reasonable asian and indian options but the Paragon is as good as it gets otherwise. That brewery is apparently just opened, been meaning to give it a go some time. The Highlands have plenty of fancy options but I suspect you are more a hearty eater than fancy eater
    • Thanks for coming back to post the update, maybe it will help out the next person!
    • Going by the intake & injectors I'd be guessing it's a DE, check the head casting number, should be 5L8 on a DET, 5L7 I think is the DE number.
    • For future reference, if you need to use Deutsch connectors but don't have the proper crimper for the round style pins, you can get regular style crimp pins too
    • No. The castings are all the same. As you have the inlet off, simply measure the diameter of the inlet ports and compare with the freely available on the net sizes of turbo and NA. The NA ones are small.  
×
×
  • Create New...