Jump to content
SAU Community

Pfc Boost Controller

YLD-CHLD

By YLD-CHLD,
in Engines & Forced Induction

 Share

Recommended Posts

260tech Proficient

260tech

Posted
Posted
Has anyone here connected a Power FC boost controller or jdetro PFC?

Where do the 2 signal wires from the map sensors go?

Are they spliced into the Front & Rear Afm signal wire at the ecu?

It looks to be cyl 3 & cyl 4 in the diagram though.

post-19124-1169772155.jpg

Hi there, hope you don't mind me butting in & I would be interested to see how your install turns out, you have a good question I think cos I haven't been to the faqs either. Just bought a D-jetro myself for my Stagea & was checkn the page u put up with your ?. Page 21 I think. Underneath your pic is the ecu pinouts which shows where things go. Cyl 3 or cyl 4 and color coding depends on which sensor goes where.

It's your call cos both those sensors are same pressure range (or mine are anyways) so can go any cyl. but wire colors are unique. Looking at diagram page 21 & 23 appears existing wires in cordset are deleted & replaced with the d-jetro jobs into ecu plug, (blue/green), hopefully sensor signal input.

Another reason I liked your question was cos my instructions were all in Nippon but now on closer inspection (pulled install manual outta rubbish bin) there may be some usuable info in there for a mono-lingual bunny like me after all. :O

Dumb question now, I thought D-jetro diff pressure sensors was so you could get around afm range?max calibrated air flow limitations, if so does boost controller kit use same sensors/setup? And/or are you more than halfway to infinitely variable boost control with the D-jetro setup?

Forgive the dq's but I just bought one cos it was shinyer than the ecu already bolted in. :pwned:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • blind_elk
      Wheel refurb?

      By blind_elk · Posted

      The powder coating came in at $250 EACH. The TRX rims got a coat of clearcoat on the outside only.    
    • The Bogan
      NC MX5

      By The Bogan · Posted

      Bit wet, but YUMMY
    • GTSBoy
      Pops when backing off throttle, rough-ish sound through rev range.

      By GTSBoy · Posted

      Keeping in mind that I am currently getting flat 10 L/100km on my RB25DET, which means >>500km/tank. I would test this car for vacuum leaks, check codes and AFM signal with NissDataScan as D says, check plugs, do a compression check while they are out.
    • Duncan
      Pops when backing off throttle, rough-ish sound through rev range.

      By Duncan · Posted

      It is hard to be specific half way across the world...but it *seems* like it might have a minor issue. Is the idle stable and does it rev smoothly? I would not expect any pops out of what I am assuming is a standard ECU, standard tune, standard exhaust. You can use Nissan Data Scan to find out exactly what is happening when it runs, the cable/software is reasonably affordable if you are not planning on changing the ECU (which hopefully you are not with an NA skyline) BTW your mileage may not be that far off, these are heavy old tech cars, and being NA might mean you use a heavy foot to keep up with traffic....
    • AdiR34
      Pops when backing off throttle, rough-ish sound through rev range.

      By AdiR34 · Posted

      Hey guys! Y'all are the masters so figured I'd check in on a few items here. - My engine sounds ever-so-slightly more raspy than the other NA RB25s I've listened to. It's barely noticeable but definitely a slightly different sound. - When I back off the throttle at high RPM, I will sometimes get a pop out of the exhaust, assuming this can be diagnosed as misfire. Some history on the car: - Had an exhaust leak in auction sheet but was claimed to be fixed by seller (bought from USA importer).  - Car's coil packs and sparks were replaced when it was sold to me, but unsure on what the gap is and whether the coil packs are correct.  - A prior mechanic had misdiagnosed a pilot or throwout bearing sound as LSPI/detonation. Had played with timing a bit, pops/raspy sound of engine just got worse. Got timing reset. - Had failed emissions a few times. First time went in as is, failed. Second time, replaced cat, still failed, running rich as hell. Third time replaced o2 sensor, passed. Car still smells gassy though. - Timing belt and valve cover gasket also replaced.  - Gas mileage is... low. about 350-400K per tank.  Any idea if I'm having any serious issues here or does this all sound like normal old NA RB stuff and I'm fine to drive it with the pops/slightly raspy engine? If it'll help, I can get drop a video of the sound of the engine.
×
×
  • Create New...