Jump to content
SAU Community

Recommended Posts

im selling a used (barely) kkr430 with the dump pipe and v-band clamp. almost brand new condition with bugger all shaft play. driven less than approximately 2000km's.

i currently dont have any pictures, but can be viewed on otomoto's site. http://www.otomoto.com.au/kkrturbo.htm

for those of you who are lazy, here are the specs;

KKR430_lg.jpg

Compressor inlet pipe 69mm, compressor outlet pipe 50mm

48 trim compressor; inducer 53mm, exducer 76.5mm

Turbine wheel outlet 48mm, outer diameter 64.5mm

im looking for $650ono, now $500. $400 picked up this weekend only! -melbourne

i want this thing gone! going to buy a new setup next week people!

call Miguel on 0432315388 :happy:

some low quality pics attached

post-30568-1171793937.jpg

post-30568-1171793974.jpg

post-30568-1171794123.jpg

post-30568-1171794164.jpg

Link to comment
https://www.sau.com.au/forums/topic/156831-sold/
Share on other sites

it actually wasnt bolted on to my car, but a mate of mine made 205rwkw on dr.drift's dyno with standard afm and injectors, someone else on these forums made 210rwkw

Link to comment
https://www.sau.com.au/forums/topic/156831-sold/#findComment-2924341
Share on other sites

  • 2 weeks later...
will this be a direct bolt on to an r33 with all the lines suiting the KKR

wanting to know this too...

also whats the power rating of it aaannndd when does boost come on?

Oh and the 205kw your mate made, was that on a 32 or 33?

:D

Musky

Link to comment
https://www.sau.com.au/forums/topic/156831-sold/#findComment-2964368
Share on other sites

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • I like they don't raise their hands into the air when they shift their sequential boxes, seems to be a thing here in Australia lol...
    • I'm not normally one for posting random videos, but I thought we'd all appreciate the honesty about how broken our cars tend to be lol. Genuine skyline life here.   
    • New CAS just turned up from NZ Wiring. Looks like a nice bit of gear.  So, yeah. Triggered, bro. Realised I may as well do the cam belt while mucking about with it so will order one of them.
    • Even more fun, leave all the ADAS stuff plugged in, but in different locations, hopefully avoid any codes!   And honestly, all these new cars with their weird electronics. Pull all the electronics out Duncan, and just shove an aftermarket ECU and if needed a trans controller in, along with a PDM. Make it run basic but race car styled!
    • To follow up a question from earlier too since I had the front bar off again (fking!) This is what is between the bumper and the drivers side wheel And this is the navigator side, only one thing but its a biggy! So basically....no putting coolers in the wheel arches without a lot of moving other stuff. Assuming I move to properly race prepping this car I'll take that job on and see how the computers respond to removing a whole bunch of ADAS modules
×
×
  • Create New...