Jump to content
SAU Community

Recommended Posts

Ok mechanic came out this morning and did a few test with the spark and the injectors and in the process blew his test light.

Told me its the coil pack.

So i go and buy a coil pack which was $110 which isnt to bad.

Fitted the coil pack and its still f**ked. Not happy, he will be coming back for round two shortly.

It is now looking like the MSD DIS 4 pack or the microtech, i hope not then its getting into the $$$$$$$$$$$$.

Link to comment
https://www.sau.com.au/forums/topic/161232-anyone/page/2/#findComment-3005902
Share on other sites

Ok mechanic came out this morning and did a few test with the spark and the injectors and in the process blew his test light.

Told me its the coil pack.

So i go and buy a coil pack which was $110 which isnt to bad.

Fitted the coil pack and its still f**ked. Not happy, he will be coming back for round two shortly.

It is now looking like the MSD DIS 4 pack or the microtech, i hope not then its getting into the $$$$$$$$$$$$.

James check the coil pack plugs make sure there clean use a little screw driver & scrap the metal pins & try again, also as some one has said check the plate the packs mount to make sure where the coil packs bolt to is clean, thats the earth point. Also check you igniter plugs ( for ser1 )on the back of the coil pack engine cover.

Link to comment
https://www.sau.com.au/forums/topic/161232-anyone/page/2/#findComment-3006271
Share on other sites

James check the coil pack plugs make sure there clean use a little screw driver & scrap the metal pins & try again, also as some one has said check the plate the packs mount to make sure where the coil packs bolt to is clean, thats the earth point. Also check you igniter plugs ( for ser1 )on the back of the coil pack engine cover.

Will give it a go thanks.

Its now been pin pointed to the MSD.

It has to be sent away for repairs does anyone know where it can be done in Brisbane.

Edited by subzeroR33
Link to comment
https://www.sau.com.au/forums/topic/161232-anyone/page/2/#findComment-3006649
Share on other sites

I may have a small window open on the weekend. I don't know if I can come to you though. I have an EXTREMELY good tow truck driver who can literally tow anything anywhere if you want his number.

He dropped J-boy's car straight into the garage for me and that car is pretty low.

His name is Steve from Pacific Towing 0412 032 023. Just tell him Daniel from Elite Racing referred you.

If you can leave it with me over the weekend I will be able to sort it out but just have been sooooo busy lately. Obviously no charge if I can't fix it.

Link to comment
https://www.sau.com.au/forums/topic/161232-anyone/page/2/#findComment-3010722
Share on other sites

I may have a small window open on the weekend. I don't know if I can come to you though. I have an EXTREMELY good tow truck driver who can literally tow anything anywhere if you want his number.

He dropped J-boy's car straight into the garage for me and that car is pretty low.

His name is Steve from Pacific Towing 0412 032 023. Just tell him Daniel from Elite Racing referred you.

If you can leave it with me over the weekend I will be able to sort it out but just have been sooooo busy lately. Obviously no charge if I can't fix it.

Its ok Daniel thanks anyway, the MSD has been sent away to be repaired so im just waiting now.

It better be the MSD as this guy has already cost me a new coil pack which didnt even need changing.

Unfortunately Ive had that tow truck driver before he is pretty good, but i dont want to risk the frontbar snapping in half.

It was a bit close last time, i think i lost a couple MMs getting it off the tray :( .

Link to comment
https://www.sau.com.au/forums/topic/161232-anyone/page/2/#findComment-3013277
Share on other sites

Why does the guy think it's the MSD?

Well he checked the power going from the microtech to the MSD and that was fine. So he said the problem is the MSD as it is not functioning properly to the coils.

It was dropping cylinders 1 & 6 from the coils apparently.

Link to comment
https://www.sau.com.au/forums/topic/161232-anyone/page/2/#findComment-3013671
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
    • Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 🙏 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 😉. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 😍 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
    • I've managed to find this: Nissan_Stagea_AutechVersion260RS (1).pdf
×
×
  • Create New...