Jump to content
SAU Community

Recommended Posts

hi

recently i notice on cold start, there will be a puff, a very small one,not one you will see unless looking at the exhaust pipe.

No it only does this when cold, a puff, and that's it, unless you give it a boot fool when cold, and then maybe another puff.

Now the turbo has had a hard life, and i am wandering if it is that in anyway, or something starting to let go. It hasn't used any oil and i only noticed it since i put the synthetic stuff in it.

Commpression is good, no leak down yet. Car runs strong andso forht.

i wouldnt worry to much if its just on cold starts.

however, could also be turbo seals, valve steam seals or piston rings.

have been told best way to check is to, pull off your intercooler pipping and check for oil. If there is oil then it will be your turbo if not then its your rings.

also check your dipstick to make sure your levels are correct and you havint over filled.

can also get a compression and cylinder leakage test, that will let you know straight away.

Edited by HKS99

thanks guys.

Yeah i will pul the pipes off to have a look. I know when I tested the compretion 2 weeks ago it was all good. Will do a leak down and so forht.

Showed my old man, who is a bit of a car buff, and he reconed it was nothing, it could be th oil in it, as it is very thin, and synthetic, FUCHS oil.

I followed the car behind, and did not see any clods of smoke out of the car while running hot, but the oil is a bit high, propably 3-5 mmover full line. OOPPPSSS.

Didn't spot this before.

by a small puff, i mean you can't see it unless looking at the tail pipe.

And if you flog it dead cold, not a thing to do anyway, you will see a white/blue smoke behind for a second or so. Not a massive plume, just enough to notice.

I think it might be turbo seals leaking a bit. OK

STOP WARYING ABOUT IT. GOT IT. LOL.

i dont see how blue smoke in any case, big or small, isnt something to worry about.

if your valve stem seals are shot then it'll only get worse. make sure it is your turbo before writing off the stem seals.

oh well if it is the valve seals, loks like i get to build my 500HP motor. LOL.

Yeah at the momenti amnot really warried about it, it mainly started when i got the new thinner synthetic oil in it, will try different bra and type next chan,approx 1k away.

She has definetly not used any oil over the past 4K kliks, so so far it's all good.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The speedo's can be very conservative, when my Mazda NC MX5 speedo is showing 118kph, the GPS, and a calibrated radar.... cop mate.....hits me at around 110kph +/- 1 or 2 kph, and that is on a 215/45 17, stock tyres size is 205/45 17 as well, so weirdly conservative with stock tyre size When my Commodore speedo red 116kph GPS had me at 110kph After doing some offset and clearance measurements to see what can fit the NC on 17x8 +40, without guard rolling or rubbing anything at my current ride height, I've decided that when my tyres are toast, I'm going to fit 225/45 17 and see where that gets me IRT actual speed of my speedo and GPS/radar From the online calculator I should be still be doing around 5kph under an actual 110kph when the speedo is showing 110kph My ADHD requires that when I'm doing 110kph on the speedo, that the actual road speed is actually really close to that, and not alot slower And going from 205 to 225 still keeps the car within the %/mm allowable in the NSW vehicle rules and regulations, which is nice, as long as I'm looking at the latest version that is.....LOL https://www.nsw.gov.au/sites/default/files/2021-02/RMS-13.464-Light-vehicle-modifications-Vehicle-Standards-Information-No-6-November-2013.pdf
    • Take the value it measured as, and pick the closest range available that is above the reading on the screen.   Also, no point just testing the coils. Read what has been said again. You need to test all your wiring, everything.
    • Does the scanner do all the CUs in the car, or only the ECU?
    • @666DAN sorry to bring you and old thread.     I've got my de+t done and it's all running great other than 1 small issue.    Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd when selected . But nothing when in  drive or what gear your in when you pop it into tiptronic. I'm sure there is maybe 1 wire in the ecu plug I need to move to rectify this. Do ya have any ideas?     Cheers man
    • Well I recently changed my rear axles and was thinking if I bumped anything, I have been driving the car for a while now though... But it has been raining today so everything is wet under the wheel arches. Brakes feel fine and can't hear any of the metal screamers, I had a squeak coming from one of the handbrake drums but that seems to have gone away a while ago. I was going down a hill when it lit up and I did feel the abs bite for a second and question why it did it?
×
×
  • Create New...