Jump to content
SAU Community

Recommended Posts

Lighthouse - no.

North/South Beach - no.

Robertson Pie Shop sounds cool. Can go up Macquarie Pass and down through Jamberoo. Great driving roads.

Again, I'm not keen to cruise with dickheads. It's hard enough to drive these things without getting attention as it is let alone travelling in a group that appears to be hooning.

+1

meet somewhere like albion park rail maccas then cruise up?

  • Replies 114
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

  • 4 months later...
  • 3 weeks later...
anyone else have experience wif WAS?

My white R33 is currently sitting in the workshop of WAS.

Kon is a great bloke. Just don't expect to rock up and have it booked in for the next day for things like tunes etc.

He's great, but busy!

Does top notch work too...

PS: i'm from Wollongong, but it's been around 8 - 10 months since my Skyline has graced the roads of Wollongong (Other then a 10 minute stint up the freeway a few weeks ago)

Whats yours getting done there?

I drove past the other day and just saw commonwhores so was a bit turned off.

It's in for a full tune.

Plus oil flush, coolant flush, and a few other things like a few PS lines changed.

Currently it's at the state if you can get it to start, it'll barely idle, won't rev much at all.

I KNOW I won't get a phone call, until it's basically driving like factory

I've given up on servicing my car now-a-days, I just can't be bothered jacking it up and doing all the shit, that it'll be going to WAS for everything from now on.

Kon does work on a lot of Holdens and Fords as he loves V8s, BUT if you go by enough, you'll see those Holdens and Fords being challenged for numbers by the WRX, Skylines, and other imports.

He deals in them all, and his quality of work is TOP NOTCH.

I just moved to Kiama last week, would be good to organise a cruise and meet some sau ppls..

Does anyone know any good workshops in the area for general servicing?

Cheers

Johno

I'm interested in a cruise this Sunday. Be good to meet at Kiama Leagues Club car park, an maybe go for a cruise to Gerringong or ????. open for suggestions.

Ive used Screamnperformance at Fairy Meadows and if you dont mined the drive JEM @ Ingleburn 45 minutes from the Gong

cheers

Yeah im from the Gong also.

Bezerkly was my choice but just do most work myself now.

Ha ha ha, I went the other way, used to do everything myself, now I just can't be f**ked jacking the car up after the conversion, so I just pay Kon @ WAS now to do it all.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Guys since i bought r33 gts25t coupe 1994 automatic a/t(manual swap 350z gearbox)  all i got is problems, always problems. Lets start with that when i turn key into ignition(ON) fuel pump doesnt always works. Sometimes i have to turn key twice Off/on/off/on until it primes. Its new, dw300 - 340lph. My gearbox broke so i did gearbox swap, install different intake manifold, injectors and i take pipes. Car was sitting in garage for more than half a year. I did assembly all not that long ago and when i turn ignition cant hear prime. All of sudden it stopped working. Theres many videos on YouTube how to make relay mod on r33 straight from battery so i did and it doesnt work! 😰 30 - battery positive  87 - positive from fuel pump to relay 85, 86 - one of two wires from original fuel pump wires(light blue, grey) and it didn’t work. so I check on ignition and took original BLUE relays wires from trunk, next to fuses. (I believe it’s IGN+ and ECU pin 18. it didn’t work…  tried connecting (IGN+ from og relay) and (ECU 104 from 1of4 FPCM wires) to my new relay 85/86 and it didn’t work.  I unplug FPCM. Didn’t work. im thinking what’s wrong   fuel pump is working, if I leave IGN+ on 85 and 86 straight to ground it works but it’s just nonstop. Since it getting constant 12v after key in ON. light blue wire gives me 6-8v.  so how this should be connected? What causing ECU not giving — on pin? Or I did sth wrong and that’s why it doesn’t work? I need negative signal on ECU that control fuel pump. What this should be?
    • You can use your VIN to look up the factory part number somewhere like amayama, and then look to order new if necessary. https://www.amayama.com/en/genuine-catalogs/nissan Depending on price you might want to rebuild instead. @GTSBoy I had an interesting insight into US market parts when the Titan rear calipers were sticking. New calipers were dirt cheap, about 20% more than a rebuild kit....they are just considered throw away maintenance items
    • Funny, but really not funny. Thank god (most) f the world has moved on since then
    • Lots of votes for driving onto a plank first; that is the quickest way I've found, 25mm is enough for my case but that will vary by car It also depends where you are going for. On the 32 I can get to the rear diff with my floor jack if I do that end first, and get it up on stands. Then I lift the front from either front tow hook as high as needed, also onto stands. Sometimes I need a small lift on the other tow hook to get it level enough If I do the front first I can't get to the rear diff because of the angle of the car Other options are getting to the front mount of the rear subframe from in front of the wheel (if only lifting one side, or just do both which is a bit of a pain compared to one lift from the diff), or also the gearbox cross member mount on the driver's side if you are  just trying to lift the driver's side. I This is the jack I use; it says 75mm clearance but of course that is only on the lower section so if you have to reach too far in like the diff you still get stuck. https://www.snapon-bluepoint.com.sg/category/Floor-Jacks/product/Floor-Jack,-2-Ton-Low-Profile
    • On the bright side, the weather will turn much nicer for working outside shortly....sounds like you might need to start on a neighbour's garden next
×
×
  • Create New...