Jump to content
SAU Community

Recommended Posts

Was flicking through an issue of Ralph Magazine which Crown gave me the other day and there's an article in there talking about the best cars in the World and in one of the side columns, there's an article featuring James and P1 International.

I think it's a pretty generic article which I read somewhere else too but I'm just wondering how many people who read Ralph can afford a years membership at P1. One would think that things like a hotted up Torana or a VR GTS would be more appealing rather than a 997 GT3 or a F430 ragtop.

I know which one I would prefer though...

Link to comment
https://www.sau.com.au/forums/topic/173176-james-and-p1-in-ralph/
Share on other sites

I HAVE to read the articles!! If I didn't I would know that Keeley Hazell was a 5'5" all natural 32DD!! :D

You simply can't tell that kinda stuff just from the photos...

Leewah reads it for the 'articles'.. sure :rofl:

My friend Rachel used to work for Ralph, as editor in chief or something, can't remember :huh:

She looked at half naked chicks all day I guess.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Thanks GTSboy. I will inspect the valves actually, is this something I can do while they are still in the head? The block/bores don’t look bad to be honest hey, I can still see the cross hatches in the bores and they still measure 86.5mm. I’m not sure how to measure the installed ring gaps but I will do that and take it to someone who can. 
    • I’ve had the same headache with my lowered car, scissor jack first then floor jack every time. Ended up grabbing an extra-low profile aluminum jack (about 70mm entry height) and it finally slides under the lip without drama.
    • No sync errors , i have installed AEM disk will return original 360 slot disk and check if there’s any one with running AEM disk could share setup 
    • Its been a while! Finally thought to do something on this car, so here we go. This will be a slow burning, multiple posts as I spend 0.5-1hr a day on this job, over multiple days... Full set of GKTech suspension arms!   Step 1: Buy Arms, done! Step 2: Start removing stuff. HICAS was easy. Rear suspension arms are now gone, they were a bitch but breaker bars with long handle extensions, 2 1.5hr slots later, stock arms are off! Next step, remove the hubs and take them to work to press out the bearings and bushings!  
×
×
  • Create New...