Jump to content
SAU Community

Recommended Posts

Can I ask why the sump and oil pump is not there and how long has it being out of rego.

Thanks Andrew

needed a new oil pump and in the process of taking the oil pump out the oil sump was cracked...

been out of rego for 3 months

Can you tell us a bit more about the car?

Any mods?

Any accident history?

Some better photos of the scratch in the bonnet and the sump where its cracked?

How long have you had the car?

Any other problems you have had/fixed prior to this one?

Was it last registered in your name?

Where are you located?

Cheers mate

Can you tell us a bit more about the car?

Any mods?

Any accident history?

Some better photos of the scratch in the bonnet and the sump where its cracked?

How long have you had the car?

Any other problems you have had/fixed prior to this one?

Was it last registered in your name?

Where are you located?

Cheers mate

pm sent

it all sounds too good to be true.i mean this car was purchased by you from someone else on these forums for $18k , which the seller stated the same problem with oil pump and yet youve taken delivery of the car and have decided its too hard to fix as well??? i think that the most people would see the motor fail before they would realise that the oil pump is cactus! i know that if i were driving down the road in my car and the oil pump ceased to work anymore or the sump was cracked i would probably not notice the problem until the engine stopped ie; my eyes are on the road more than the oilpressure gauge.

it all sounds too good to be true.i mean this car was purchased by you from someone else on these forums for $18k , which the seller stated the same problem with oil pump and yet youve taken delivery of the car and have decided its too hard to fix as well??? i think that the most people would see the motor fail before they would realise that the oil pump is cactus! i know that if i were driving down the road in my car and the oil pump ceased to work anymore or the sump was cracked i would probably not notice the problem until the engine stopped ie; my eyes are on the road more than the oilpressure gauge.

thanks for your input mate!

Ive been through hell and back having had both my cars broken into just 2 weeks ago hence the reason Im selling not your assumption of too hard to fix.... Im gutted having to sell it!!! Unless your interested in buying this car dont post here..............

may be iam interested in buying the car that is why iam asking you the tuff questions ...

You havent asked any questions you have made assumptive comments...

If you have questions I will answer them.

If you have comments please do not post here.

BigCarl you make some very worthwhile comments,

I am also interested in this vehicle although it does seem like there is more to the engine problems than just the sump and oil pump whether Dan knows about them or not, having not had the car running I would assume he does not.

And Dan i'm sorry that we are not asking questions but your thread is the logical place to get info from other skyline owners/enthusiasts about what the potential buyer might be up for when purchasing your car.

I think if you want your money back for the car you should get a written mechanics report from a reputable skyline workshop because anyone buying this is taking quite a risk and therefore is reluctant to part with their hard earned when they could be up for a big bill before even getting behind the wheel.

That said, i'm considering coming to have a look at it with some equip to check the engine out and have a good look at it. I'll pm you when I can work out a day to get time off work and we can arrange it.

Cheers mate

Guys I just want to say, this car is listed at $18990 for gods sake...

Obviously there is a risk with buying anything and I cant assure the engine is fine but thats the reason its listed for $18990ono....

Its not like Im asking $26000...

Inspections are welcome anytime...

yes but $18990 plus $8500 for a rebuild equals $27499! another question why is there no timing belt? i rest my case ...

timing belt is in the boot, was taken off along with the radiator and condensor to change the oil pump and sump...........

What are you trying to achieve by putting the car down so much???

Its either you want to buy or you dont...

Plus $18990 is the asking price, its not set in stone...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drive beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
    • Hello!  i just finished manual swaping my r34 skyline with a r33 rb20de box(RB71C)box  When the car is running it squeaks crazy loud and it was smoking from the gearbox area. The gearbox is fine it was tested. The clutch slave cylinder seems like it doesn't fully releases the clutch. I want to ask if this noise is from the throw out bearing or could it be the clutch assembly or disk att.xFliq87Gzw6kImKBVqDebXkj0fBqymk0JaYeP3_3SlM.mp4
×
×
  • Create New...