Jump to content
SAU Community

Recommended Posts

Hey guys,

I'm selling my TEIN coilovers, they are in very good condition only used for short time in my R33 as car got sold.

and now have no further use for them.

They are in fantastic condition and suit both R33 and R34 4door.

Would like $900 but negotiable as always.

Also have ZCAS japanese performance breakpads. 4 Pads They are brand new in box, suited for R32. $150

Located in adelaide. Local pickup is welcome and am also willing to send interstate.

Cheers

post-20233-1184485304_thumb.jpg

post-20233-1184485346_thumb.jpg

post-20233-1184485426_thumb.jpg

post-20233-1184485467_thumb.jpg

hey mate i am keen on the coil overs, how old are they and can i get the model numbers of the side, fark you had them set low......

hey mate i am keen on the coil overs, how old are they and can i get the model numbers of the side, fark you had them set low......

hey mate, i only had them in my car for a couple of months.

i'll pm you the model numbers after work tonight.

where are you located?

just out of curiousity how much are you charging for postage to brisbane qld 4301 for the coilovers

i've sent a pair to qld before a while ago and i think i paid $80 registered post

i'll double check though

u say these will go on 4doors but wat about r34 coupes

not quite

the front is exactly the same on the r33 and r34 coupe and sedan

however the rear set is a bit different, the mounts are the same, but the bottom of it is different between the coupes and sedans.

whats the rear look like on yours?

spring rates???

pm me ur best price to brisbane..

not too sure of spring rates, was quite a comfortable ride though.

coupes and sedans have the same suspension setup for GTT. Unless you are comparing NA and turbo then there is a difference. So if yours came off a GTT sedan, it will definately fit a GTT coupe.

coupes and sedans have the same suspension setup for GTT. Unless you are comparing NA and turbo then there is a difference. So if yours came off a GTT sedan, it will definately fit a GTT coupe.

i'll post up pics of the difference between coupes and sedans, just so that someone doesnt end up buying it and it doesnt end up fitting.

hope this will take care of the confusion, the standard struts are from an R34 COUPE

the bottom of the strut is different shaped to that of the coilovers, the mounts on the top are exactly the same.

I'm not sure if every R34 coupe is the same though.

post-20233-1184978303_thumb.jpg

post-20233-1184978334_thumb.jpg

post-20233-1184978365_thumb.jpg

Sorry don't mean to spam ur thread, jst want to set the record straight, as I mentioned before, GTT coupe and sedan suspension is exactly the same (front strut has an eye and rears have the fork)

What you have should fit an NA R34 sedan or coupe or a GTV as they are called. They have an eye on the rear strut instead of a fork. I have attached pics of my Teins to suit GTT sedan or coupe. Hope this clears things up and GL with ur sale.

post-6973-1184979998_thumb.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • sold listed as a Tomei LSD 1.5 Way For 1998+ Nissan Skyline ER34 25GT RB25DE w/Open R200 https://www.ebay.com/itm/174006114594?campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=&mkrid=711-53200-19255-0&loc_physical_ms=108689&loc_interest_ms=&campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=71883f2ccc571356e0a757bc7adfdde2&mkrid=710-53481-19255-0&loc_physical_ms=108689&loc_interest_ms= it went in like butter all gears, alignment, back lash etc, rotation and clearances correct, and if rolling all rotates smooth and free when coasting down road , clutch in or out over 10 mph smooth... its the binding, clunking and jerking from a stop that is most concerning, also seems like its going to tear the tires off in 10 miles of normal road driving. 
    • What 1.5 way? There's no such thing really as a 1.5 way, just different ways of explaining 2 ways with different ramp rates. HOWEVER. In any driving in a straight line your 1.5 or 2 or 1.7 way should have no clunking at all. With the clutch fully depressed the diff should be silent (unless it's welded but I'm assuming it's not). Something aint right here.
    • Clutch is a spec brand, new clutch system,( PP, flywheel, friction disc, etc. pull type) installed 100 miles ago, with no problems.
    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
×
×
  • Create New...