Jump to content
SAU Community

Recommended Posts

  • Replies 46
  • Created
  • Last Reply

Top Posters In This Topic

If it helps a little when you use aero start then maybe there is still a chance its not getting fuel.

As far as ignition goes you can get a spark guage that you plug into where your s/plug normally goes. You can basically increase the gap wider and wider to see how strong the spark is. That would be one way of making sure you have a good strong spark even in combustion environment.

You need to set it up on compression on number one cylinder and make sure its firing on TDC #1

i reckon you should swap your ecu. try that out. for your car to be sitting there for so long there may have been condensation build up. i know because this happened to me. i got water in my ecu. do you have rats? maybe rats chewed your wiring somewhere. no joke

R.I.P RB26DETT...

55psi measured in cylinder one and two...

19th September, very sad night

Thanks for all your help guys, much appreciated.. specially to you Robert for recommending Dan to me!

Dan.

Edited by Rude Carz

the acutal problem was the loom had a AFM piggy back system and there was no continuety between the ecu and injectors... i tested with a test light with a LED and it showed up but that things shows up like .02V so.. hmm

the landings on the pistons have been stuffed due to racing :S it woulda started but it wouldnt be nice or run long..

Edited by Rude Carz

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...