Jump to content
SAU Community

Recommended Posts

Hey guys im attempting to change my starter motor this weekend. Not very familiar with rb20 engines but i do have some knowledge on mechanics. Is it a easy enough swap over? can it be done by the backyard mechanic? lol is there anything i should know about that will save me from cursing all morning? tips/help/advice

thanks in advance

Dave

Link to comment
https://www.sau.com.au/forums/topic/180863-replacing-starter-motor-rb20/
Share on other sites

disconect your battery to start of with

it preety easy to do you will need a 12mm spanner and 14mm spanner 10mm spanner for battery

all you do is disconect batt, remove wires on starter one will be a 12mm nut and the other will be a push on wire

undo two 14mm bolts and pull it out

and install is reverse just make sure yoou compare your old one with new one to make sure there the same

it is preety tight to get your hands in there but shouldnt take you any longer than a hour to do it.

and its easyer from the top than the bottom

well gave it ago today, with no luck, and the short spurt of rain didnt help either lol. I just couldnet manage to undo the one bolt. managed to get the bottom one off piss easy but the top one, couldnt get my hands or a spanner in there. is there a special shaped spanner or socket piece i could you to squeeze it in there?

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Kinkstah, no, coilovers aren't illegal, especially as a bolt straight in. The illegal part will be if they're altering suspension geometry beyond factory limits, or the ride height is not legal.   Sounds like the blue slipper just didn't want to deal with any later possibility of mods appearing on the car.
    • The problem has always been that coilovers are able to be adjusted, almost at any time, to be too low. Most people who ever get/got defected for/with coilovers were actually afoul of the minimum ride height rule. So the interpretation by cops/inspectors was always that it is pointless to allow numpty to raise his coilovers and get the car inspected/cleared, then just drop them back down again as soon as they get around the corner from the inspection station.  This led to the interpretation that they were illegal unless rendered such that they can't be adjusted (ie, collars welded to the body, that sort of thing). That may or may not have ever actually been the official line, but I'm pretty sure it's not considered to be a solution these days. Coilovers themselves fall under clause 3.2 b of that manual, because they are an "installation of a variable ride height system" and they don't fit the exclusions in that clause (which point to air springs and other pneumatic adjusters). So, as per previous statements, they require engineering cert to be legal on the road. Once you have such cert, provided you do not adjust them outside the height range covered by the cert, you are OK. Without, you have an unroadworthy vehicle.
    • Here E10 is the cheapest fuel. And general advice is to not use it unless you hate your car. From what I remember it clogs up stuff in the fuel system or injectors?  With US/Canada being E10 across the board, does that mean that all fuel there is terrible?
    • Sorry, are coilovers ACTUALLY ILLEGAL in NSW? They aren't in Vic, as long as they retain 70% of stock travel and the car is above 100mm off the ground. Does NSW actually have a law making coilovers actually illegal? RWC/Blue Slip/Engineering people not knowing the actual f**king laws boils my blood. Demand them to point to the documentation that states a coilover is illegal. (it may exist in NSW ) Edit: I checked. They aren't. https://www.nsw.gov.au/sites/default/files/2021-02/RMS-infosheet-light-vehicle-modifications-manual-suspension-and-ride-height.pdf
×
×
  • Create New...