Jump to content
SAU Community

Recommended Posts

OK guys & girls im looking/thinking about selling my pride & joy to upgrade to GTR but will only sell at the price i want! No offers!

STRICTLY EOI AT THE MOMENT!

1996 Series 2 GTST with dual air bags, Rare Active Lsd Model, now with mechanical diff

$18,500 rego expires on Nov 2 07

127,000kms serviced regularly 3,000-5,000kms

Plates WPN-033

EXTERIOR

R32 GTR Rims with new rubber on the Front, will supply standard rims painted black

Stealth/Drift wing

Nismo 400r Style Side skirts

Fibre glass lip on standard bar - in bad condition.

Reverse Sensor... comes in handy

Clear Nismo Indicators

INTERIOR

TRUST gear knob

Knock link

Blitz Dual - SBC boost controler

Clarion CD player

Central locking

3 point immobiliser

Window tinting

Greddy Twin A-Pillar with 1 x Air fuel ratio & 1 x Boost gauge

ENGINE

Hybrid front mount intercooler

Greddy catch can with earls firrings

Master cylinder brake brace

Sard 500hp fuel pump

Sard 650cc fuel inj. Std injectors will be provided

Sard fuel pressure reg.

Splitfire coils

Highflowed turbo by Precision Turbochargers

Brand new Braided Oil lines to the Turbo

LINK ecu

3 inch exhaust from turbo back

Blitz NUR Spec muffler

Exedy heavy duty single plate clutch

K&N airpod with cold air induction through the front bar

HANDLING

Tein HR height adjustable coilovers - Also will supply original suspension

GTR rear sway bar

Tomei electronic Hicas lock kit

Brand new Brake Pads Bendix Ultimate on the front

Bendix pads on rear

Mechanical diff. pretty sure its a 2-way

Adjustable rear camber arms

Serviced just this week 15/03/08

I had the car dyno tuned recently at Croydon CRD, Also fitted a new CAS- Crank Angle Sensor & new 5'' Stainlees Cat Converter.. 3/8/07

Power is 232rwkw on 17-18psi

Most mods were perfomed by Advan Performance & Had engine Drive belts replaced earlier at SAS .

All dyno sheets & receipts will be provided

PM If you are interested in this car.

Pics gtrrims.jpg

gts55.jpg

Link to comment
https://www.sau.com.au/forums/topic/188182-r33-gtst-s2-silver-with-mods/
Share on other sites

I see this car everyday. It is tough yet subtle, goes bloody hard and sounds horny as.

I'll put it this way, if you are in the market for an R33 Series II you need to have a look at this car. I seriously doubt you'll be able to resist paying the asking price once you experience this package.

  • 2 weeks later...
:D

might you be interested in swaping for a GTR?

http://www.skylinesaustralia.com/forums/t187303.html

PM SENT.

Hey thanks Drew, i will miss it if it goes...

Hey phill, thanks for the kind words, & yeh i know lea has a nice car to swap but hmmmmmmmmm its not nice for me :dry:

Hey bill..

Can really give the thumbs up to this car..True and honest example of a series 2..the hard works been done and the mods are there to back up all the work..(DONT SELL IT BILLY)you might not miss it but i will..haha

Owner will defanatly not look back.. geniune car guys..

  • 2 weeks later...
  • 1 month later...
  • 3 months later...
  • 1 month later...
  • 4 weeks later...
  • 1 month later...
  • 2 weeks later...
  • 4 years later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Photo of manifold showing gate location? I mean, it's 6Boost, so we probably shouldn't be worrying, but always wroth knowing what the layout is. Plumbed back to atmosphere? Or into the dump?
    • Yes correct. Also, I'd avoid applying it to soft paint (however I doubt you'll ever have to deal with it in practice). So any paint that hasn't fully hardened, could be a 1k paint that never fully hardened or it could be a 2k paint that was laid down thick and hasn't yet fully hardened. 
    • Bit of an update to this one. Having some issues on the dyno that held us back (boost spiking) and I want to pass some info over you guys and see what you think is wrong with my setup. The current readout on this dyno is 462rwkw on a low reading dyno so keep in mind it is a real world 500rwkw setup on a hub dyno. Don't read into the power figure too much as a sign of the issue. The short and curly of it is: 2.8 Litre Racepace build RB25 NEO N/A Head with VCT (internally standard however ) Borgwarner EFR 8474  Turbosmart 50mm Straight Gate + Mac valve 6Boost Manifold 4" dump to full 4" exhaust (nil restrictions) Wastegate plumbed back in and all angles in the exhaust system are acceptable and not too sharp. GFB SV52 BOV in cooler piping  Turbosmart BOV in EFR Housing   The issue we are having is it comes onto full boost for example at 4000rpm and spikes to 24/25psi, before dropping down to 17psi before slowly rising back up to the target boost of 23psi. It was extremely uncontrollable and the tuner actually had to ramp in boost progrssively with each 1000rpm on each boost setting we selected to try and reduce the amount of spiking. Sometimes we would see a drop of 10psi from the peak at the beginning of the run, to the low, until it took the next 500-1000rpm to stabilise back up to the target boost. The tuner is pretty confident that the straight gate is just a poorly designed product and leaks too much boost upon cracking the gate open and theres no way to fix it other than going to a poppet valve. He's also confient theres no ignition breakdown or floating valves. The fueling is extremely stable as well. Turbo speed is somewhere around the 109,000rpm area. The spanner in the works for me is that prior to this Borgwarner and StraightGate, the car was tuned on -5 twins at a diferent tuner, and he also had issues controlling the boost with it spiking around the same rpm range, so to me this sounds like the same issue and it can't be anything on the turbo side as this was all changed and I think the behaviour is extremely similar, if not the same. We also removed the mac valve and did a run on wastegate pressure and it still spiked and had the same behaviour. My thoughts on possibilities are: Boost Leak VCT Cam Gear isn't reliably activating consistently - (On this however, we did a run with the VCT disabled and the boost still spiked) Turbosmart BOV is not handling the boost? However this seems unlikely to not be able to handle 20psi. I have a couple of logs that I can't make sense of if anybody knows how to read them and can obtain further logs of other parameters if they are not enough, happy to pay for anyones time. The dyno readout with the power figure is the most recent last week. The other picture is from two weeks prior to that where we couldn't break 400kw (we removed the cat), however the issue of the boost control persisted. @Lithium @Piggaz @burn4005 @GTSBoy @discopotato03 I've tagged those that were quite active in recent pages here, no disrespect to those that know turbos well but I missed tagging. Cheers 
    • I recently purchased a 2018 Infiniti Q60, which has an SD card navigation map. I can see my system has options for real time traffic updates etc, and am wondering if there is something I can purchase to get this working? I can see there are at least updated maps for USA and Canada, but nothing for Australia. Surely Infiniti took changing road systems and city expansions into account when they decided to use an inbuilt navigation over Android Auto/Apple Car Play, or are we doomed to drive on streets that don't exist in the navigation system if you drive to a new area?
×
×
  • Create New...