Jump to content
SAU Community

Recommended Posts

Hey guys, my GTR which is pretty much stock (including ECU) will start fine when its dead cold and it runs perfect for like 10 mins.

once it gets up to normal temp it just stall itself and wont start again untill its been left overnight and gone cold again.

the only thing that has been done to its is last month i had my surge tank and 044 installed ready for new injectors and ECU and tune up..but it was running fine with that installed for weeks.

im not really sure at all whats causing it, but my guesses so far have been perhaps AFM, Coil Packs, water temp sensor, igniter module getting too hot, maybe is it possible fuel lines are getting too hot and creating vapour lock in the rail.?

at the moment the car is left sitting in the car wash down the road from my house until i can arrange to get it moved or fixed.

and help would be much appriciated.!

thankyou :nyaanyaa:

Link to comment
https://www.sau.com.au/forums/topic/190534-r32-gtr-stalling-then-not-starting/
Share on other sites

starting to look more and more like the igniter module but i need to find one somewhere to test it and see.

has gotten to the stage where it wont start at all now..just keeps turning over..replaced sparks and fuel lines.

starting to look more and more like the igniter module but i need to find one somewhere to test it and see.

has gotten to the stage where it wont start at all now..just keeps turning over..replaced sparks and fuel lines.

If you need an igniter, go here http://www.perthzperformance.com.au/ I got two from here, good service. Easiest way to check the igniter is to hook up CONSULT at a NISSAN dealer.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Pads for R32 GTS-t, R32 GT-R non V-Spec (Sumitomo), R33 GTS-t and R34 GT-t are all interchangeable. R34 GT uses a 2x piston caliper, hence it didn't fit.
    • Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
    • I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
×
×
  • Create New...