Jump to content
SAU Community

Recommended Posts

just rewmoved my bleed valve and need to go back to stock boost so i can drive the car... i have one hose coming from what is a pipe underneath my intercooler piping on the left side of the engine (facing the car's front end)... one from the intercooler piping itself and on form the turbo's actuator (i think that what the gold drum thingy is)

and i have the stock boost solenoid which has two connectors and electrical wires coming from it.. so where does each tube go.. dont want no overboostin lol

cheers...yup that helps lots. Is useful i think for others too who might not know what it is ;)

Are those wires blue w/ white stripe and white? I have an orphan plug sitting around, just wondering whether its the same one. Does it require power or is it fully neumatic?

hmmm.. well i have the solenoid in place.. From those photos it appears the bottom hose from the solenoid is going to the wastegate, where as the top hose is to the throttle intake? So all should be fine right?

Unfortunately its not, when i connected it like that infinite boost..it just kept going up and up until about 12psi till i backed it off ;)

There is also a blocked outlet on my (stock) BOV return pipe where it goes back to the turbo, so maybe the top hose is meant to go there? Although the pressure should be pretty much the same shoudlnt' it and make little difference?

I mean i can "cheat" and just connect the intake direct to the wastegate and it will hold correct boost (which i'm doing for running around) but its for an EPA so the solenoid needs to be connected (i think?)

Anybody ?? Quicksmart? if anybody has a standard boost solenoid can they jump out to their car and have a close look plz?

Hi,

The bottom line on the solenoid goes to the T piece that in turn goes to the wastegate actuator (where your bleed valve probably is).

The top line on the solenoid goes back off into the BOV return line. As I recall, it's under the air piping that leads into the turbo inlet.

The striped wire (to the right of the plug) is a constand 13.5 volts

The solid colour wire (the left of the plug) is a negative trigger controlled by the ECU to open the solenoid.

The solenoid is fully electric.

line goes from high pressure side of the intercooler to the waste gate, then a "t" piece, the "T" peice runs a hose the the boost control solenoid, then from there to the hose that runs from the standard BOV to the low pressure side, (between turbo and AFM).

ok.. well i got it all sorted the other night..the key is the t-piece between the intake side and the wastegate - the stock solenoid hangs off that, and its different to my EBC configuration where it sits in between. Now rises to a solid 7psi

In the aid of providing a useful resource, i've posted a couple of pix of how I installed it

All was inspected and passed by the EPA correctly :D

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Good timing mate, welcome to God's country just in time for winter Seriously though....how cheap is rural/regional.
    • Thanks guys! Some pics attached 😋
    • Big enough for you, Jackie, and some puppers mate! I vote some GSDs, but I am biased   How big of a block is it on?
    • Well, fun day was had, I finally found a house that will do me just fine, 1980's brick build, but with full fresh renovations, plus new colour bond fencing all round so puppies are incoming 🐕, and water tanks for the garden, and it's located in West Goulburn..... @Duncan 🫡, so day trips to Wakie to watch cars going Zoom will be on the cards In the end it cost well under my budget and was actually better than alot of the more expensive joints I was looking at, it is in a good area, close enough to the shops, public transport, and the Wollondilly River Weir,  and the great walking paths along the river, but far enough away from town to see minimal traffic The deposit is dropped, the conveyancer is conveyancing and I should get the keys in a week or 2 as the property is currently unoccupied  As with everything I own, I'm doing up a modifications list, as it doesn't have solar, that is first up on the big list, all of the panels and enough batteries to keep the joint warm, or cool, followed by a largish carport out the front, the small list, which will start as soon as I have keys, is some security stuff, like cameras, screens, and the usual "crazy prepper" additions that weird old people like (mouse holes to stick shot guns out of, and the usual man traps that the average person installs for the unsuspecting and unwanted guests 🤣) The gardens front and back are OK, but, not to my standards or liking, so landscaping will be a fun job to start getting into, so when spring is sprung I'll do a heap of planting, lots of natives and vegetables is the plan, the old owners were more "Old English Garden" type, so basically Roses and other weird looking things that are destined for the green waste bin One thing that is staying garden wise is a nice established hedge out the front, it is about 5 foot tall and covers the whole front of the property from prying eyes As for the car hoist, the roof in the garage has some height to it, but, I'll need to get an installer out to see what can be done, width wise may be a issue, but my building inspector will be getting back to me over the next week with his recommendations  Small, but cosy     
×
×
  • Create New...