Jump to content
SAU Community

Recommended Posts

Item:RB20det complete low km motor out of cefiro with cefiro crossmember (good for s13 conversion)

Age:1991 ceffy halfcut

Condition:in very very good condtion,complete motor with turbo very low kms all stock(no gear box)

Price:$1900 o.n.o

To Fit: (What car)R32,cefiro,s13

Location:adelaide

Contact:PM for mobile number if ur serious

Comments:(cefiro had 56K KM on the clock when chopped) great set up for a s13 rb conversion

(also have ECU and loom)

Price drop

will sell as short motor for $1450 minus crossmember,turbo,loom and ecu

or complete setup for $1800

Edited by streetcredit

PRICE DROP

WILL SELL THE RB20DET AS A SHORT MOTOR FOR $1350

THIS IS A LOW KM RB20DET CAME OUT OF A CEFIRO HALFCUT WITH 56K ON THE DASH CLUSTER (DASH CLUSTER HAS BEEN SOLD B4 PPL ASK

IM BASED IN ADELAIDE BUT CAN FREIGHT ANYWARE IN AUSTRALIA WITH MAINFREIGHT

CHEERS

Edited by streetcredit
what exactly does it come with??? computer/loom???

pm me asap with more info as im in Adelaide and could pick up asap.....

ADRIAN

PM SENT CHAMP

QUOTE(AdrianA @ 5 Mar 2008, 06:59 AM) *

what exactly does it come with??? computer/loom???

pm me asap with more info as im in Adelaide and could pick up asap.....

ADRIAN

PM SENT CHAMP again

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Totally equivalent. Stock often goes from the comp cover because that's where the actuator is also installed and the factory needs 2" of hose to make the connection - and it comes as a pre-assembled unit. They totally have a boost reference from somewhere between the turbo and the throttle(s). Oh, jeez. Just do it in M12 then. We don't actually care that much. I would expect any such AN converter fitting to rely on an o-ring or some other seal onto a flat surface under the flange of the hex**, because bolt threads are no intended to provide a pressure seal. unlike..... pipe threads. **which also requires a suitably flat and smooth surface on the turbo's boss to provide the seal.
    • I also used NP   That’s were it’s seems to be the best place to fit it? All schematic shows also that it’s should be referenced from the turbo housing. But idk, I do see high hp cars without any connection or anything to their turbos, so I really don’t know how they connect their things
    • I do have loctite 243 and 246 and a few more models. I could drill it now in place and make new threads for m12 and order an4 - m12 coupling and fit that to the turbo. Run a braided hose to the EBC which I could get a an4 to 1/8npt 
    • So M12 and sealant should be fine?    NPT ” because that’s what I had and what I could get atm. 
    • Wouldn’t touch par if they gave it to me. You need to ask how much power you’re looking to make and then add about 50% to it because that’s what you’ll end up making  The factory box says no more at about 350kw or so, the upgraded synchro boxes won’t handle much over 500kw for long and at that point you’re looking at an auto or dog engagement manual,  once you’ve gone dog engagement you may as well go sequential, they cost a little bit more but it’s worth it  also while you’re at it you should upgrade the transfer case with 10 friction plates 
×
×
  • Create New...