Jump to content
SAU Community

Recommended Posts

Hi guys, as it says i have a bosch computest engine analyser that i purchased off my previous employer that i no longer need.

I am selling this as a compleate package and i am not seperating or shiping interstate and the price is firm

and its pickup only so dont pm me asking me to seperate, negotiate price or ship interstate. because the answer will be NO!

If you have no problems with that please continue reading

Bosch Compact test Engine Analyser

complete with printer, 4 gas analyser, engine monitor, oscilloscope, timing light etc.

everything works just some of wiring for testprobes needs some tlc and i think the c-mos batery needs replacing.

other than that it works.

Im Asking for $250 $150

I am located in sydneys western suburbs

Pick up only, may require trailer or ute.

If interested you can contact me Via PM

or Ph 0433750636

Kind regards

Dave

post-40206-1207450206_thumb.jpg

post-40206-1207450219_thumb.jpg

post-40206-1207450230_thumb.jpg

Edited by MR FLWLSS
whats the model number of it ?

No Idea. if you have a clue were i can find them i will post them up

  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Update: tested my spark plugs that are supposed to be 5ohms with a 10% deviation and one gave me a 0 ohms reading and the rest were 3.9ohm<, so one bad and the others on their way out.
    • 9" wheels are a little too wide for a RWD 32. They can fit. People have put R33 GTR wheels on 32s for years and years. But they are a very tight squeeze. This has been known for about 30 years. As I said - there is no difference between a 17 and an 18 in terms of what will fit. The rolling diameter needs to stay about the same as stock - not very much larger. If you increase that, you will start to have problems. If you increae rolling diamater at the same time as yo increase width, you will have problems earlier. as 9" wheels are pushing the boundaries already, you would need to be careful with tyre choice. I would put 8.5s on the front of mine, but would expect problems with 9s.
    • post up screen shots of your injector tables
    • Diagnostic flow for a code 21 says check signal at the ECU pins, on a voltmeter of some kind it should read 0.1V at idle, 0.12V cranking, 0.15-0.25V at 2000 rpm. Check each coil such that +1, -3 is infinite or very high resistance, -3, +2 should do the same. (-1, +3), (+3, -2), (+1, -2), and (-1, +2) should all be somewhere between 0 ohms and high resistance. If you trace the path from the coil pin all the way back to the ECU in the diagram the resistance you measure at the coil vs connected to the harness should be pretty much the same. 
    • I have an elite 2500 running an adapter harness on an rb25de neo r34. I took the butterfly out and removed all that junk. But I also went Plus+t at the same time. The butterfly thing works in reverse to the boost solenoid on the Gtt if that makes sense
×
×
  • Create New...