Jump to content
SAU Community

Recommended Posts

When you guys go to the track do you strip your car at all ? and if you do what do you take out ?

I was thinking subs / amp's / back seat / space saver & jack etc..

What about rear tyres ??

Does anyone know much about this ??? does it help much ?

how far could you let down 235/40/18 tyres before your going too low in pressure ? they normally run 40psi of pressure could you let them down to 25 ok ?

What pressures do you guys run in your tyres when you race down the 1/4 mile ?

What tricks do you guys do to your R33's to give you an advantage over the quarter ?

took out my sub box, space saver (which i am now leaving out (fcuk it), and dropped my tyre pressures to 20psi.

Re: other tips, my best run to date involved loading up on the handbrake with the clutch almost all the way out and then dropping the brake and clutch at the same time.

Also have pineapples etc to get rid of typical skyline axel tramp.

Adrian

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Let large companies that are making money off selling kits do the preliminary engineering for you. If they all do -10, then that is all you'll ever need. 
    • Hopefully it ends up being something manageable, like a hone, rather than a full bore—it would be a huge relief if it’s not as bad as it looks. Hang in there; these setbacks are annoying, but it sounds like you’re handling it as smartly as possible.
    • At the end of the day, it’s all about understanding the odds and being comfortable with the potential cost, whether it’s horsepower on a build or chips on a roulette table. And I have to say, the Laine example made me laugh—some people really do embrace that carefree, “roll and see” attitude!
    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
×
×
  • Create New...