Jump to content
SAU Community

Recommended Posts

Make sure you buy one thats been serviced at a mazda dealer that way you know everything has been done on time.. and if you can buy one still with some warranty.

The major services are every 40,000kms and the are upwards of $450 but all the other services should be below $280 so long as you dont have any extras needed.

They are a good car though.. and i'm not just saying so because i work for Mazda :thumbsup:

Link to comment
https://www.sau.com.au/forums/topic/216714-mazda/#findComment-3828246
Share on other sites

get the mazda 3, i work for them and we barely have any probs with them. we get sum that come in and they say they get around 600 - 700ks per tank of fuel. the best ive heard is 1000ks per tank.

I can vouch for that. Very nice car. The Mazda 3 Maxx Sport never gets under 600k out of a tank, typically I get more than 660k per fill. They drive with mercedes like handling, and have enough power in the 2.0L petrol variant for driving to make it satisfying to drive without planting the accelerator. And most impressive of all they are quiet, and stay quiet after a few years too!

The car is very handy with the roof racks on full time, still very quiet, and tow bar too.

The ONLY SINGLE fault and enough to make me rant about it that I can make of this vehicle is the air conditioning,

which I have been told needs to be changed to a custom aftermarket solution for the condensor panel to make it blow hard and cold.

It is cold enough to maintain a comfortable temperature just not strong enough to do something like bring it down to sub 20 degrees celcius on a 38 degrees celcius day.

A typical summer day like that and it will sit at a constant 23-26 degrees on the freeway regardless of the a/c fan speed setting.

I need an air conditioner to go to at below 20 degrees no matter how hot it is outside. This is because after exercising running around and run back to the car, I feel sweaty and need to cool down to get rid of the humid feeling.

I guess this car was made for Japan with the expectation that you will park your car in an undercover car park during the day at the office, not for active Australians, who have to leave their car in the sun, and who after doing so and driving for 2 hours will expect to eventually cool down in the car, which will never happen in this car.

Link to comment
https://www.sau.com.au/forums/topic/216714-mazda/#findComment-3828319
Share on other sites

Mazda 3 is a nice car,

was almost going to buy one... then on the drive to the mazda dealership I spotted a sleek looking car on the corner of a car yard, turned out to be this quirky thing called an r33 skyline.

ended up buying the skyline (talk about a completely different world) and started my love affair with imports, was never a big fan of cars before then. Go figure

Link to comment
https://www.sau.com.au/forums/topic/216714-mazda/#findComment-3828942
Share on other sites

lol I was going to buy the mazda 3 as well, never ever heard of a skyline b4 that

but whilst browsing on the net, I found this awesome looking silver s2 skyline

went for a test drive and all that practicality shit went straight out the window :D

Link to comment
https://www.sau.com.au/forums/topic/216714-mazda/#findComment-3829753
Share on other sites

lol I was going to buy the mazda 3 as well, never ever heard of a skyline b4 that

but whilst browsing on the net, I found this awesome looking silver s2 skyline

went for a test drive and all that practicality shit went straight out the window :down:

Well I just sold my Skyline after two years of ownership and really need to find a cheap to run but nice and reliable car (looking to spend between $16-$23K)

Im also buying a house soon so hence why I cant really afford to keep a fuel hungry PULP drinking car.

Link to comment
https://www.sau.com.au/forums/topic/216714-mazda/#findComment-3830763
Share on other sites

I can vouch for that. Very nice car. The Mazda 3 Maxx Sport never gets under 600k out of a tank, typically I get more than 660k per fill. They drive with mercedes like handling, and have enough power in the 2.0L petrol variant for driving to make it satisfying to drive without planting the accelerator. And most impressive of all they are quiet, and stay quiet after a few years too!

The car is very handy with the roof racks on full time, still very quiet, and tow bar too.

The ONLY SINGLE fault and enough to make me rant about it that I can make of this vehicle is the air conditioning,

which I have been told needs to be changed to a custom aftermarket solution for the condensor panel to make it blow hard and cold.

It is cold enough to maintain a comfortable temperature just not strong enough to do something like bring it down to sub 20 degrees celcius on a 38 degrees celcius day.

A typical summer day like that and it will sit at a constant 23-26 degrees on the freeway regardless of the a/c fan speed setting.

I need an air conditioner to go to at below 20 degrees no matter how hot it is outside. This is because after exercising running around and run back to the car, I feel sweaty and need to cool down to get rid of the humid feeling.

I guess this car was made for Japan with the expectation that you will park your car in an undercover car park during the day at the office, not for active Australians, who have to leave their car in the sun, and who after doing so and driving for 2 hours will expect to eventually cool down in the car, which will never happen in this car.

yeahthey will get that all the time. we always get people that ask about the a/c with them but the way 2 get them realy cold is have them set on recurculate instead of fresh. we have tested 1 car that on a 34 degree day we had the ac sitting around 7degrees.

Link to comment
https://www.sau.com.au/forums/topic/216714-mazda/#findComment-3833912
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Don't even try to run it on the stock ECU if you're going to have the boost controller bring boost above ~10 psi. I've already told you that. If you use the Nistune ECU, you will need to CAREFULLY read the available documentation for Neo tuning, and read some threads on the Nistune forums, to discover the various things you have to do to prevent the ECU from going bananas when the boost is too high. The is a table associated with th boost sensor that must be modified to prevent it from shitting the bed. This is just one of the things that you will need to do to the tune in Nistune, because the Neo turbo ECU will be expecting to see a number of things (such as the TCS) that are not there, and you have to block the DTCs on those. It is totally not surprising to me that you are having the problems that you are, but the solutions to these problems have been known for >15 years. So just get it done.
    • Hi. Sry iam not a mechanic and iam not at the car atm so i dont know 100% but they told they measure those and even try to change those. AFM they have two. Coils are new a they have my old one too. Plugs too. ECU...we have 25 NEO stock and Nistune 25 NEO.   But i dont know if any one those could be the problem and why/if/what can cause this, Only thing they did not check is fuel...but that walbro 255 is new(like 1,5 years)... That fuel pressure gauge idk...but i let them know Any suggestions?   EDIT: how can they know if it is like you say he ECU pull power when it reaches a specific boost level that is too high? Tha car has boost controler
    • Can you clarify what you mean by boost cut, do you mean it misfires both when under load (driving) and when stationary and out of gear? Or does the ECU pull power when it reaches a specific boost level that is too high (boost control issue)? Does it occur at idle with no throttle? When you say "the ECU is OK", what ECU is it and why do you think it is OK? Have you used the NEO ECU, and if so do you have a MAP sensor attached? Same for the AFM, why do you think it is OK? Do you have any way to put a fuel pressure gauge on it (even just a mechanical one between the fuel filter and fuel rail)?
    • Hi.. Just another problem. So maybe you can help. I(my mechanic) done swap from my RB20DE NEO to RB25DET NEO. Everything is OK but we have a boost cut. Coils/Plugs are ok...AFM is ok. ECU is ok. I have Walbro 255 but it "changed" sound few months ago(you can hear it ouside) you did not hear that when it was new(maybe faulty?) Sooo...what now? What can cause this boost cut? It is even when you standing still...
×
×
  • Create New...