Jump to content
SAU Community

Recommended Posts

Basically all you need is a camera with a high speed continuous drive mode..the 40D one shoots up to 6.5fps which is handy..you can do it with a lower speed camera but obviously you wont get as many frames.

best done with a tripod (although mine above were done handheld) i then take the photos in photoshop and put it all together and the result is what you see :banana:

the angle is important too..the one below, I had 15 frames and only used 5 because I didn't want too much overlap...so that all happens pretty much within a 2 second time frame

for the lazy, i've put the actual image up into that post instead of just a link.

470bc7b0aa8a72d0fab2a4ce872d4141.jpg

  • 3 months later...
  • Replies 51
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

been a major slackass lately.

so heres a quick panning shot I did of this roller...thought panning in car shots..why not try it in sports...i seriously don't know where the hell tight pants came into the scene though..*shudder*

5ab8a726b1e0443e52524538bdc4da06.jpg

it wouldve been good to have gone wider, and had the approach+landing but ill just say its a proof of concept ;)

  • 1 month later...

Been awhile. Haven't taken any photos lately except for a few more skating ones.

The little kid split the rail and smashed his nuts nicely..was painful to watch hahah

More experimenting with off camera lighting

3297024778_d0e4b3c58a.jpg

3291927347_f631d12431.jpg

  • 4 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • 40 grit sounds about right, to start. You make some decent cuts/damage in the coating with that, then rapdily scale up to maybe 80 and 120 for the bulk of the actual removal, then fine it off to 180 or 240 perhaps. No need to go any finer than that, and maybe no need to go even as fine as that. Wrap it on a big block and have at it. At least on the hub face.
    • Do the GKTech rear lower control arm mount relocation, and either alloy subframe inserts or very stiff subframe bushes. Traction is going to be at a premium!
    • Hello,   My name if Frederick, i'm 30 years old and I live in Belgium, Europe! I used to have a Nissan 370z daily but since I got a company car I turned that into my seattime driftcar. About 3 years ago I also wanted something older with more feel, so I got an R32 GTST with an rb26 engine. I am now getting the rb built to have around 800hp and it's close to being finished. I'm very excited for how it will drive and how driveable it will be! Regards, Fred!
    • Appreciate the insight! Talked to some local folks and they basically told me "it's not that deep." As long as the threading on the inside matches what's at the steering rack, everything else can be constructed-to-fit. There are full aftermarket kits I can use - probably better for my car overall since it's lowered.  Example: GKTech M14 Super Adjustable Inner Tie Rod Set - Nissan Skyline R32 R33 R33, 240SX, 300ZX, 350Z / Infiniti G35 M14I-TROD-2 gktM145-TROD gktM14I-TROD - Concept Z Performance (These can be packaged with their "high misalignment" tie rod ends).
×
×
  • Create New...