Jump to content
SAU Community

Recommended Posts

my alarms got a inbuilt turbo timer so speaking on personal experience no.

if your using 2 different aftermarket products. the only thing the turbo timer might to is delay the time wen the immobilizer kicks in.

If you get ur immobilizer proffesional installed(which you should, no point risking your car for a few bucks) with the turbo timer, it will have no ill effects whats so ever.

Im running a good alarm (Wont mention brand) and turbo timer, both were installed at the same time.

I can have my turbo timer on for 2 or 3 mins, arm my alarm, and the alarm will activate. If someones breaks into ur car while the turbo timer is on, and tries to drive the car away, the alarm will turn off the turbo timer immediately.

So no, it wont have any effects on ur immobiliser.

However i do recommend you go for a full alarm system rather then just the immobiliser... too many skylines get stolen now a days.

Hope this helps

Brendan

If someones breaks into ur car while the turbo timer is on, and tries to drive the car away, the alarm will turn off the turbo timer immediately.

You will find a properly installed turbo timer will shut down immediately if the handbrake gets removed, or if the brake is applied, these are 2 features that are genuinely associated with the security of a car being timed, so that if someone was to jump into the car and either hit the brakes (usually done when clutch goes in to select gear) or drops the handbrake (again, required to take a car), the timer shuts off.

A decent alarm system should activate, and the turbo timer should be connected in some way to a timed by-pass of the immobilising function of the alarm system for timing down, but not effect the alarm system in it's monitoring of battery drain circuit, vibration monitor, etc.

And if your bothering to install an alarm, make it decent, a $90 'alarm system' from Dick Smith Electronics just WONT cut it, might meet insurance, but anyone with remotely any level of auto-electrical knowledge will bypass the cuts instantly and easily.

B.

i had install the alarm system(Dunno is that good enough or not, Cost-$120) which will immobilize the car when press the lock button recently. Was thinking to install a turbo timer to my car too, which make me free for minutes after i reach my destination. Was thinking to install myself for the turbo timer, since i saw some tutorial is quite easy to install with just plug the hardness.

But since Brenden had said that, dun waste few bucks for the risks, i was 50 50 thinking bring it to pro install. But is that hard or unsafe to apply a turbo timer with current alarm system myself? if someone know the safe ways or safety tutorial to install the turbo timer i'm really appreciate for your help.

Yang

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hi Guys, Does anyone know any aftermarket part numbers for a starter motor to suit the VQ25DET? I can find lots of alternative part number for the VQ35DE, which I assume would fit, but there is a lot of conflicting information out there. Thanks..
    • I don't understand how this hasn't boiled down to - Upgrade the turbo when you have everything required. ECU, injectors, fuel pump, turbo, etc. Do it all at once.  If you don't have everything required, just enjoy the car as it is and keep saving up your pennies. 
    • Sounds like you've got an interesting adventure ahead here with local support if you have trouble! My guess is that, unboosted, you will be OK with a small upgrade like -9. What will happen is that once the stock ECU sees more airflow than it expects it will add a heap of fuel and pull a heap of timing to be safe because it can't understand how it could get that much air without there being an issue. You will see clouds of black smoke and it won't pull hard through the midrange and top end. So, overall it will be a bit frustrating but should be OK. If you are still nervous set the base timing back 2o through the CAS, but it will be even more sluggish everywhere. As said above through...this is not my guarantee your engine won't be blown into a million pieces, leaving you looking for very hard to find parts A better idea is get a computer with logging ASAP, wire in a wide band O2 sensor and a use remote tuner. I've done multiple cars this way and while it is not as good as a specific tune on a dyno they can get it 90% right. I'd suggest if you can afford an R33 GTR these days you can afford an ECU and tune. And if you can't afford that you sure won't be able to afford the rebuild if it goes bad in the meantime,.  
    • Yeah it would be nice if someone took the time to put that sort of information together, but there are a lot of variations in looms. I think you are making this way hard for yourself if you just want to get it running....sourcing an SR20 with the right wiring will be a billion times easier than matching the RB loom to an S15 chassis. If you do end up going this way, you just need to trace every wire in the loom with a multimeter, 95% of them will go to a location you can confirm at the ECU.....and then post it up for the next person who needs it  
    • Just top it up with water, and keep a general idea of how much you added. It is normal for water to be pushed into and pulled out of the reservoir through the cap, and it should not be more than half full or it will be likely to overflow when hot. Any decent mechanic can do a pressure test of the cooling system to confirm if you have a leak. Keep in mind if it is only leaking a little and when hot it may well evaporate before you see it hit the ground
×
×
  • Create New...