Jump to content
SAU Community

Recommended Posts

Item: Set of 4 Buddy Club P1s & Good Tyres

Age:Dunno

Condition: Good

Price:$625

To Fit: (What car)S12, S13, R31, R33 N/A

Location:Sydney, Northern Beaches

Contact:PM or 0402 030 038 (no sms)

Comments:

Get a good quality set of Jap wheels for your S12, S13, R31 or other 4 stud car.

Wheels are 16" - Fronts are 7.5" wide , Rears are 8.5" wide

PCD is 114.3, 4 stud - suit Nissan 4 stud arrangement

Offset - +13 for Front, +27 for rear

No scrapes or scratches - great condition

All tyres are around 90% good

Front Tyres: Bridgestone PlayZ 205/50 R16 - very sticky tyre, made in Japan

Rear Tyres: Falken ZE326 225/50 16 - made in Japan. Slight Guard wear to tyre wall, only cosmetic.

PICKUP ONLY FROM NARRABEEN - Please don't bid unless you can arrange pickup. I will not post these.

PICT0626.jpg

PICT0627.jpg

PICT0628.jpg

PICT0629.jpg

PICT0630.jpg

PICT0631.jpg

PICT0632.jpg

PICT0633.jpg

PICT0634.jpg

PICT0635.jpg

PICT0636.jpg

PICT0637.jpg

Link to comment
https://www.sau.com.au/forums/topic/222296-fs-buddy-club-p1s-tyres/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...