Jump to content
SAU Community

Recommended Posts

the stereo in my stag when i got it was no good. it asked for pin code that i didnt have and no remote even if i had the code. anyhow i put the cd player from my 1600 in the stag and the speakers n splits are clear as anything at low volume. but when you turn it up its still clear and loud for about 10 15 seconds and then all speakers at once just distort badly untill you turn it right down then you can turn it up itl be clear and then distort and so on and yeah.

the head unit was fine last time i used the datto and ive pulled the trims off and speakers look fine, connections look fine. anyone got any ideas?

Link to comment
https://www.sau.com.au/forums/topic/225486-weird-problem/
Share on other sites

What's the wiring like?? The Japanese have a sad devotion to scotch(?) clips/joiners in almost every car they touch: maybe the wiring can't handle the load because of this? Have you checked ALL wiring between the head unit and the speakers?

Link to comment
https://www.sau.com.au/forums/topic/225486-weird-problem/#findComment-3971363
Share on other sites

ive lookt over most the wiring i can see, when i pulled the old head unit out there was just a huge bundle of wires there dodgy as shit. i rekon il just rewire it all. or test another speaker. and wire?

Link to comment
https://www.sau.com.au/forums/topic/225486-weird-problem/#findComment-3971391
Share on other sites

Start simple: if you have another speaker, fade all sound to it, and see if it does the same thing. If it does, then consider changing speakers. In what way did it look dodgy? Were there heaps of joiners, spliced wires, etc?? I generally make it a rule to rewire all stereo in a car as soon as I change the head unit: it gets rid of any crappy joins, and decent wiring almost always improves sound: factory wiring is barely adequate due to cost, and by putting decent gear in, you at least know it's been done right. :D

Use a logical process of elimination to ascertain what the issue is, starting with the easiest things tocheck, and going from there: it's the only way to make sure...

Link to comment
https://www.sau.com.au/forums/topic/225486-weird-problem/#findComment-3971413
Share on other sites

i dont have another headunit round and when i go out buyn stuff for the stag i always enden spending a shit load. i might have a look on the net to see if i can reset this deck that came out of it. looks like a good one. it had lcd video playn of rally cars n that, but thats all it was good for.

Link to comment
https://www.sau.com.au/forums/topic/225486-weird-problem/#findComment-3971477
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • You're retired Mark, on bin night, go for a walk, kind of like you're doing the beep test. Put one rock in the first neighbours, come back, get another rock, go to the second neighbours, repeat over many weeks. All rocks eventually gone...
    • No chop chop of anything mate, it is what it is, plus, I don't want any air that isn't either going through the cooling stack or intake getting into the engine compartment increasing under bonnet pressure  Yeah, the Mazda Speed aftermarket intake above is less than ideal for multiple reasons, the requirement to remove the bumper every time you need to service the filter, and also smaller in diameter than the NC1 OEM one Weirdly, Mazda Speed is part of the Mazda motorsport division, "form over function" and $$$$$ for Mazda from unsuspecting punters I suspect  After some googling about them it seems they added no power, but do increase some induction noise Meh In other news, the electricians have been busy today at the house, and are back tomorrow finishing up all the security stuff and exterior lighting, they also added some lighting on the garage ceiling, which will come in handy when working in the garage when it's not freezing out there My Birdies raised garden bed also arrived today as well, which I'll put together and place tomorrow, it's a big tall Bessie, 74cm high, 92cm wide and 214cm long, this will come in handy as I am starting to get "stockpiles" of good soils from doing landscaping, some of the clean rock, namely the river stone, will go into the bottom of the bed for drainage, as well as the old Apricot tree that was out the back,  and when it's full, I'll grab another one, I will be growing enough veggies to keep me both busy as well as supplementing the shopping list I'm also awaiting another quote for a new Colourbond front fence, as the "1980 style cemented in rock edging" that was there and "fashionable at the time" looked arse, and my god, the amount of cement used to fix the rock was insane, it took 1.5 days for me to break out 12 meters of the stuff by hand, trim the bushes back to the fence line and dump it out the back of the joint to deal with at a later date,I will soon need a skip bin to tip it all Unfortunately they did alot of the cemented in rock around the joint, which I hate, so a few pallets of retaining wall blocks for around the front and back where the cemented in rock is will be required to bring it up to a standard, and look, that I will be happy with 12 meters worth of rock and cement Finished smashing the fence line and ready for a fence to be installed, yes, the lawns need some TLC and thickness, the previous owner trimmed the grass to the roots 😢, the TLC I can provide, and nature over time will do the rest And there's probably about another 40 meters worth of this landscaping abomination left to do around the front and back gardens, I'm guessing maybe 3 or 4 tons worth, tip fees for this will be a killer Meh, all in all I'm having fun and keeping busy, plus, it's good PT
    • If I drove to a typical petrol station, what would my choices of fuel be? 
    • Just cut the bottom of the guard out. It's no longer got a big duct, to a sealed box, or a restriction. It has all the cold air from outside. Also, that cai you showed looks terrible. Bends are NOT good for go gos!
    • Like I said, "black magic" LOL In the end,  it is what it is, and hopefully, what this here knuckle head has done is an improvement and not a hindrance Not that I actually notice any negatives now, or that I will get any seat of the pants benefits when all is said and done, but best practice says I shouldn't be pulling intake air from the hot engine bay  Famous last words: I cannot see it being any worse than what it is at the moment 🤔
×
×
  • Create New...