Jump to content
SAU Community

Recommended Posts

No, I didn't say that. You were wrong before. You first mentioned rb30e and e is EFI version. Carb version is S.

Do you have more pics of your car ? Interior ? Exterior ? Engine pics ?

RB25DET will fit in. You will have to wire it in into your car wiring. And you got to buy EFI fuel pump with bracket. I'm not sure if gearbox will go in without modifications. And rear end is a bit different. You could make it fit I guess, but you should find someone who knows what he is doing.

I know what do you say ...

all what do you say already changed !

can you see this pic ! only difference number on the diff case 10000 ,, the number in the pic 9000 ...

Thank you advance ...

casedifferencefulljx1.th.png

Edited by bkc
Differential: - All are R200

84-86 Z31 Turbo: 3.54:1 - Open

09/86-04/87 Z31 Turbo: 3.7:1 - Open

04/87-89 Z31 Turbo: 3.7:1 - Clutch LSD

All of the above differentials will fit.

I would use the Z31 Turbo: 3.7:1 Clutch LSD diff. It will be more than strong enough for an RB25DET and should give you the top speed range you wish for, the LSD is a very good unit as well.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...