Jump to content
SAU Community

Recommended Posts

Yeah its a pretty easy job.. as above, back seats out.. I took parcel shelf out for that bit more room..

Make sure you do it on flat ground if u can..

the few bolts at the top of the struts are generally easy enough to take off and the bottom bolts on the stock gear might be a bit tight but just hit that with the breaker bar and it will come loose...

Only other thing if yours are similar design to Buddy Club, make sure u cable tie ur brake lines to the strut as you may not have mounts on the new struts for them. Don't want them getting damaged.. :D

Also, tighten, lower the car, tighten again (strut tops)..

Umm other than that pretty easy.. should take maybe 4 hours even if you don't know what your doing..

PS: lower the car slowly the first time after install cos you can never be too sure how low they come from the factory.. (in my case too low, lol)

Link to comment
https://www.sau.com.au/forums/topic/231171-need-help/#findComment-4060902
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Lock me in mate, although I'm not sure if I'll be heading up from Goulburn or down from Sydney, either way, return will be back to Goulburn 
    • Sounds good, we will aim to be there! @The Bogan I'll give you a shout if you are heading up to campbelltown for the meet too.
    • Before I get to the test day, just to finish off the android head unit. This is a demo from car start up....the standard/host system takes a few seconds to boot (same as all v37) but Android comes up quickly. In this vid I'm using the delivered launcher but have set the default to Agami since which is easier to navigate when if use primarily 5 apps. You can see the host system still takes over when required eg putting it in reverse, and you can switch between Android and not by holding the back button 3 sec. It is pretty responsive (fast) but you can see I had to press harder than expected a couple of times.  I still have the phone connected to the stock system, and that also seamlessly takes over Android music playing. v37-android-demo.mp4 The bigger reason that I put this in though is so that I can use Ecutek directly on the head unit. That gives me a dash with logging (up to 20MB only), high and low value warnings on any parameter etc etc. I've run a USB cable from the Ecutek OBD dongle to a USB input on the unit, easy. v37-ecutek-demo.mp4   The unit did freeze on the launcher the other day, I think Agami was trying to verify the license when it didn't have a data connection...will monitor and report back if there are any other problems but so far I'm very happy with the upgrade.
    • Nah that is just crappy GPS mapping, I did have a small excursion (cold tyres, damp track, surprise!), will post up that when I get a chance.
    • So 10/10 times that code is coil packs? I mean if that's the case ill drop the $400USD or so to replace them. I didn't know these cars threw codes before the issue became an issue.
×
×
  • Create New...