Jump to content
SAU Community

Recommended Posts

Had a sickie today.

wondering what I should say tomorrow.

or should I go to the docs today. cant be bothered really.

had a big wkend, sore back from ATG festival.

whats some excuses.

Tell the boss you had a cramp in your ovaries!

Link to comment
https://www.sau.com.au/forums/topic/236116-sickie/#findComment-4133288
Share on other sites

yeah Its my last sickie left till they start again in a couple weeks. need a cert to get paid.

I honestly cant be bothered goin to the docs. money or not.

I was there a couple months ago complaining about something that wasnt really there . haha

just thinkin of something to say tomorrow :banana:

Link to comment
https://www.sau.com.au/forums/topic/236116-sickie/#findComment-4133303
Share on other sites

I usually say its something I ate the night before. that usually gives me 1 - 2 days .

last time I went in I said this.

They played around with my stomach and said there is some stuff going on in there.

I was fine.

So who is the liar ?

Link to comment
https://www.sau.com.au/forums/topic/236116-sickie/#findComment-4133338
Share on other sites

I am with Sled on this one

My work doesnt require a sick certificate if its only 1 day.

If however its 3 or more days then i definately need a doctors certificate

So i am guessing its the same for you as well craig.

And as for excuses:

1. a massive headache

2. Diarhea (not sure of the spelling lol)

3. bad cough, runny nose and general soreness (possibly from something that you ate over the weekend, blame some restaurent for that)

Link to comment
https://www.sau.com.au/forums/topic/236116-sickie/#findComment-4133400
Share on other sites

Issue here is that your sick day falls on a Monday - a day after the weekend, so they'll most likely ask/demand a sick certificate otherwise they will assume you're partied hard all weekend!

My previous workplace used to have the same policy - if it was a sick day mid-week, no questions asked, but if it was a Monday or a Friday, they came down hard on you!

Link to comment
https://www.sau.com.au/forums/topic/236116-sickie/#findComment-4133410
Share on other sites

how aussie is this? finding ways to justify sickies :banana:

haha yeah. there was a massive similar thread on ns.com not so long ago.

maybe I should just have tomorrow of too. and see the doc tomorrow when I can be bothered.

Link to comment
https://www.sau.com.au/forums/topic/236116-sickie/#findComment-4133435
Share on other sites

Issue here is that your sick day falls on a Monday - a day after the weekend, so they'll most likely ask/demand a sick certificate otherwise they will assume you're partied hard all weekend!

My previous workplace used to have the same policy - if it was a sick day mid-week, no questions asked, but if it was a Monday or a Friday, they came down hard on you!

where i work if your sick day is immediately before or after your weekend, you need a sick cert, or if you have 2 or more days off in a row.

Link to comment
https://www.sau.com.au/forums/topic/236116-sickie/#findComment-4133604
Share on other sites

pretty sure my EBA states 3 days of without a certificate and 7 days with a certificate.

If I wish to be paid.

you sure sled ?

Federal Awards may be different to State Awards??!

Issue here is that your sick day falls on a Monday - a day after the weekend, so they'll most likely ask/demand a sick certificate otherwise they will assume you're partied hard all weekend!

My previous workplace used to have the same policy - if it was a sick day mid-week, no questions asked, but if it was a Monday or a Friday, they came down hard on you!

Cronic makes a good point here.......it may be up to company policy if it falls on a Monday or maybe even on a Friday.

Link to comment
https://www.sau.com.au/forums/topic/236116-sickie/#findComment-4133756
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Even more fun, leave all the ADAS stuff plugged in, but in different locations, hopefully avoid any codes!   And honestly, all these new cars with their weird electronics. Pull all the electronics out Duncan, and just shove an aftermarket ECU and if needed a trans controller in, along with a PDM. Make it run basic but race car styled!
    • To follow up a question from earlier too since I had the front bar off again (fking!) This is what is between the bumper and the drivers side wheel And this is the navigator side, only one thing but its a biggy! So basically....no putting coolers in the wheel arches without a lot of moving other stuff. Assuming I move to properly race prepping this car I'll take that job on and see how the computers respond to removing a whole bunch of ADAS modules
    • So I prepped the car for another track day on Wednesday (will be interesting to see coolant temps post flushing out and the larger reservoir, with a forecast of 3-14 being 20o cooler than last time I took it out). Couple of things to mention; since I am just driving the car and not taking a support vehicle, I took the rear seats out and just loaded the back up Team Trackday style. Look at all that space! To cover off removing the rear seat....it is weird (note the hybrid is probably different because it wouldn't have folding rear seats) Basically, you remove the lower seat base, very similar to a r series but it is a clip that pulls forward to release the base rather than it being bolted down. Easy Then, you need to remove the side section of the rear seat on each side. There is a 14mm head nut at the bottom of the side piece, the it slides upwards off a hook at the top to release; you also need to unhook the seatbelt from the loop at the top. Then the centre piece is weird. You need to release/fold the seats forward with the tab in the boot on each side From there, there are 2,x12mm headed bolts holding the rear of each seat to the folding bracket, under the trim between the rear seat and the boot (4x christmas tree clips there, they suck). The seat is out but you can see where the bolts attach to the bracket
    • As discussed in the previous post, the bushes in the 110 needed replacing. I took this opportunity to replace the castor bushes, the front lower control arm, lower the car and get the alignment dialled in with new tyres. I took it down to Alignment Motorsports on the GC to get this work done and also get more out of the Shockworks as I felt like I wasn't getting the full use out of them.  To cut a very long story short, it ended up being the case the passenger side castor arm wouldn't accept the brand new bush as the sleeve had worn badly enough to the point you could push the new bush in by hand and completely through. Trying a pair of TRD bushes didn't fix the issue either (I had originally gone with Hardrace bushes). We needed to urgently source another castor arm, and thankfully this was sourced and the guys at the shop worked on my car until 7pm on a Saturday to get everything done. The car rides a lot nicer now with the suspension dialled in properly. Lowered the car a little as well to suit the lower profile front tyres, and just bring the car down generally. Eternally thankful for the guys down at the shop to get the car sorted, we both pulled big favours from our contacts to get it done on the Saturday.  Also plugged in the new Stedi foglights into the S15, and even from a quick test in the garage I'm keen to see how they look out on the road. I had some concerns about the length of the LED body and whether it'd fit in the foglight housing but it's fine.  I've got a small window coming up next month where I'll likely get a little paint work done on the 110 to remove the rear wing, add a boot wing and roof wing, get the side skirt fixed up and colour match the little panel on the tail lights so that I can install some badges that I've kept in storage. I'm also tempted to put in a new pair of headlights on the 110.  Until then, here's some more pictures from Easter this year. 
    • I would put a fuel pressure gauge between the filter and the fuel rail, see if it's maintaining good fuel pressure at idle going up to the point when it stalls. Do you see any strange behavior in commanded fuel leading up to the point when it stalls? You might have to start going through the service manual and doing a long list of sensor tests if it's not the fuel system for whatever reason.
×
×
  • Create New...