Jump to content
SAU Community

Recommended Posts

  • Replies 51
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

either way, they undid the wrong doings of another cop, in my books that deserves praise. but noone praises the cops when they do good, everyone just shoots them down when they do 'bad', if doing your job is a bad thing.

off topic, your car looks sick in your sig.

Yeah true, the cop could of just told him to shove it and make him waste his money and time taking it to regency but they undid their wrong and got someone to come out to re-check and remove the defect sticker.

oh and cheers ;)

hey cubes are those heights for r33 as well or just r32

R33 and R32 have different heights, also it makes a difference if its turbo or N/A.

Best bet for any defect is to contact regency to confirm actual requirements!

does anyone know if the R34 heights have changed ?

or is it still a 32km gap between centre wheel and arch.

errr do you mean cm a km is a long way

Edited by mid life crisis
does anyone know if the R34 heights have changed ?

or is it still a 32km gap between centre wheel and arch.

I'd like to know too.

Although I went through without problems with 350 front 350mm rear.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • all brand new unit from Tomei, fluid, bearings, etc. Tomei said they call it a 1.5 lsd because its 100 percent lock up under acceleration and 50 percent under deacceleration.  as I mentioned I used their fluid, install and their break-in procedure, (alot of figure 8's) but even when driving straight, or even slowly backing out of garage for first time, (at 2 mph) then driving to and from figure 8 parking lot, each tire in the rear would sporadically grab, skip, bounce, shutter and skip, shutter back a force I could feel causing clutch to slip then grab, at any speed. shaking entire car. I removed unit, since I put stock back in and all is fine, via process of elimination, its something with the lsd unit itself. I wasn't going to beat up the entire car more or change anything else for no reason as I had a feeling something in the lsd itself was wrong as everything was fine before this alone was installed and I rechecked over everything else after first time backing out I suspected an issue. I'll probably sadly already need new tires now just from trying to drive it 5 miles and performing the figure 8 break in. but if someone has any ideas I'm all ears 
    • Ok thanks..that was my second question if i can somehow bypass this even with Nistune(that is all i have right now...aparat from stock ECU. So with some aftemarket it can by "bypassed" or make it work?  I know there is Link or Haltech (mainly used). We have ECUmaster here so i will gather some info about it.
    • Yes. You will need to get the original boost sensor and wire it in. That is.... if you plan to use a stock ECU - even a Nistuned ECU. The Nissan ECU will not operate correctly without it connected. And yes, it will do annoying stuff like you are experiencing. You will almost certainly be better off with some aftermarket ECU, than trying to hunt down rare sensors.
×
×
  • Create New...