Jump to content
SAU Community

Fujitsubo 3" Catback

bored33
 Share

Recommended Posts

bored33 Grand Master

bored33

Posted
Posted

Item: fujitsubo 3" catback exhaust

Age: 4 years

Condition: good

Price: $400 ono

To Fit: any R33

Location: rosemeadow

Contact: pm or 0412 773 767

Comments: selling this system because i just upgraded to a larger exhaust. there are scratches on the muffler due to concrete driveways not being low enough :P its a direct bolt on to your r33 from the cat onwards, no mucking about. i am negotiable on the price so throw me a decent offer.

fujitsubo.jpg

Link to comment
https://www.sau.com.au/forums/topic/239231-fujitsubo-3-catback/
Share on other sites
mmjc Enthusiast

mmjc

Posted
Posted
Item: fujitsubo 3" catback exhaust

Age: 4 years

Condition: good

Price: $400 ono

To Fit: any R33

Location: rosemeadow

Contact: pm or 0412 773 767

Comments: selling this system because i just upgraded to a larger exhaust. there are scratches on the muffler due to concrete driveways not being low enough :bunny: its a direct bolt on to your r33 from the cat onwards, no mucking about. i am negotiable on the price so throw me a decent offer.

fujitsubo.jpg

Looks like it needs a good clean and it'll look brand new... I have a Fujitsubo on my gtt and can vouch for its quality and minimum noise. Nothing comes close when it comes to exhaust... :banana:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Latest Posts

    • MBS206
      R32 update from 1990's spec.

      By MBS206 · Posted

      With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • joshuaho96
      RB26DETT Sketchy boost mod?

      By joshuaho96 · Posted

      This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • djr81
      R32 update from 1990's spec.

      By djr81 · Posted

      So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • djr81
      RB26DETT Sketchy boost mod?

      By djr81 · Posted

      Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • ARB26
      RB26DETT Sketchy boost mod?

      By ARB26 · Posted

      I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
×
×
  • Create New...