Jump to content
SAU Community

Gtss Turbos What Other Mods For Over 330kw

PHA71L

By PHA71L,
in Engines & Forced Induction

 Share

Recommended Posts

R31Nismoid Grand Master

R31Nismoid

Posted
Posted

320-340rwkw is what the GT-SS will make when pushed. Whatever they make in and around that, is what they make and thats all there is too it.

Dont get too set on a 'figure'.

If you want a 'figure' then just play with the dyno settings, its easier and cheaper.

PHA71L Community Regular

PHA71L

Posted
  • Author
Posted

im not after big numbers was just woundering?

so in a r32 they could be good for 10s? with semis... :P

im going to go a sard fuel pump...

should i change to nismo afm also?

i was reading they are good for 450hp? or is not worth pushing the stockers?

also when is a hard pipe kit needed? ill be staying with the stock cooler.....

thanks in advance steve

R31Nismoid Grand Master

R31Nismoid

Posted
Posted

well you can run a mid 11 on stock turbos driven hard, so i see no reason why a high 10 cannot be done

yes fuel pump

yes AFM's

Also injectors need changing

Stock piping is fine, if stock piping is fine for 400rwkw GTR's, good enough for you.

PHA71L Community Regular

PHA71L

Posted
  • Author
Posted

o really thats alot! thanks for that!

i just installed the sard 720s so ill do the fuel pump next and the wire mod...

then turbos and drive it softly down to get tuned with the afm hmm getting excited now :P

Marko R1 Grand Master

Marko R1

Posted
Posted

i ran an 11.1 @ 129mph with my r32gtr with hks gtss setup, with my mph i should have ran a high 10 but i kept it in 3rd gear across the line (on the limiter for about .5sec) dumb mistake!

im @ 325awkw but will be pushing for more once i get my forged bottom end done

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Black_CSR
      Wheel Sizes & Offsets For Skylines

      By Black_CSR · Posted

      Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.    
    • Kinkstaah
      Wheel Sizes & Offsets For Skylines

      By Kinkstaah · Posted

      If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • GTSBoy
      Wheel Sizes & Offsets For Skylines

      By GTSBoy · Posted

      If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Black_CSR
      Wheel Sizes & Offsets For Skylines

      By Black_CSR · Posted

      Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • MBS206
      MAJOR FUEL ISSUES 25det neo r32

      By MBS206 · Posted

      Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...