Jump to content
SAU Community

Syd Wrecking 1988 Laurel Maroon Drivers Side Rear Door/sill Damage


Recommended Posts

hey all

im wrecking a laurel maroon in colour, maroon interior, no motor gearbox, is a rolling shell with complete interior

has impact damage to drivers side rear door/sill

front is in good condition for those of u that want to put it on ur cefiro

vehicle has compliance, in 1990 probably the first laurel australia no doubt hehe, has no rego

pm me for parts or any info

will post pictures on request

can have the whole car for $500ono

offers welcome need it gone

cheers,

brad

Link to comment
Share on other sites

  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • Suppose in your part of the world, however here in Australia, the Xtreme Twin Plate Organic is still cheaper than any Nismo or ATS clutch.
    • Getting back to the actual subject though the Xtreme twin plate I'm a little skeptical of. Higher clamp force + requires a pull to push clutch conversion. I'm not super sensitive to cost but the ATS clutch is 700 USD more and another 35% extra clamp force over the Nismo. With how weak the yen is the Xtreme organic twin plate is actually substantially more expensive than either the Nismo or ATS clutches as well, although I haven't priced everything out after shipping.
    • R35 shift times are woeful, garbage gearbox. If you could ZF8HP that, then it would be better (probably nearly impossible)
    • Most likely if the speedo works fine it's the driver circuit in the cluster that takes the VSS signal and converts it into a neater format for the ECU/HICAS/etc. Pull your gauge cluster out and clean the board with contact cleaner, all that fun stuff. Look for corrosion, signs of burned contacts, failed solder joints, etc.
    • Hi guys, Driving along today, my engine light flicked on showing code 14 speed sensor circuit. It came on when i was cruising in 5th at 70kmh. No noticeable change in the driving experience, no slip light or anything else. Speedo works fine, the only thing that's different is my bulb in the bottom left of the dash has gone. So I know this is going to be a dumb question but the bulb couldn't possibly be throwing this code? Otherwise I have no clue where to start, apparently this code could be anything along the speed sensing circuit? So speed sensor and wiring back to the ECU etc. Is there a way to test the speed sensor to see if it's faulty? If anyone is able to point me in the right direction to start would appreciate it. Cheers
×
×
  • Create New...