Jump to content
SAU Community

Recommended Posts

  • Replies 47
  • Created
  • Last Reply

Top Posters In This Topic

Legends! - i only live 5 mins from there so im filling up there from now on dont care what the price is...aslong as they have Premium or Ultimate even if it is full price..... to bad its only THAT BP thats doing it.....im not supporting them because i will save 20 buks if i go and fill up there but because of the fact that they are taking money out of there own pocket to help everyone

This is why i asked if they sold Ultimate.....I know it's only regular unleaded thats cheap.

Id rather give this lady(BP) my money then the big one on the highway that i normally use.

Both are roughly the same distance from my place. So no biggy.

+ i could score some free eggs. LoL

Petrol Price Drop tomorrow

The 12 servos dropping their unleaded price tomorrow morning (Thurs 30th Oct between 8am and 9am) to 99.9 cents/litre include:

Speedway Smithfield, 26 Cumberland Highway;

Speedway Meadows, 359 Elizabeth Dr, Mt Pritchard;

Speedway Unigas, Haberfield, Parramatta Road;

Speedway Auburn, 238 Cumberland Rd, Auburn;

Bp Independent Williamstown, Victoria Rd;

Bp Independent, Blacktown 163 Sunnyholt, Rd;

Bp Independent Denistone, Quarry Road, Ryde;

Rebel Petrol, Earlwood, 200 Homer St;

Metro Croydon, Hume Hwy Croydon;

Metro Bankstown, 158 Sth Terrace;

United Granville, Mona St Granville;

Speedway Fairfield, Horsley Dr, Fairfield

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...