Jump to content
SAU Community

Recommended Posts

Had a search around and not much luck. I am in the market for a Stagea, I am really keen on getting the touch screen unit but the RS4 I have found (which is in great knick!) doesn't have it installed. Has anyone, or does anyone know whether the touch screen out of another Stagea can be easily swapped over? Anyone know what $$$ these units go for second hand?

Cheers everyone!

Link to comment
https://www.sau.com.au/forums/topic/242374-touchtv-screen-in-stagea/
Share on other sites

forget it, completely different wiring harness for Air conditioner controls, and you will not have the ability to feed video into it easily. Choose one or the other, but don't try to mix them, it will only lead to tears.

If you are after an AV setup then an aftermarket pop out screen is the best option. The Xanavi touch screen will handle most of the AV requirements (eg, mine has tv tuner/GPS/reverse camera through it) but the screen is somewhat small and low resolution, but neat.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Have you confirmed its the actual axles? Also the wheel bearings that mount on the hubs to hold the axles wear out. I replaced mine as they got play in them. It sorted my play issue. 
    • Ive converted a few clusters for the R33 with 320km/h dials. On the back there are some pads which can be bridged or unbridged (using solder or wick braid) to calibrate it. There is one bridge which is for MPH <> KPH; and there are combinations of bridges to offset it. There is probably a diagram  For example; this is my conversion for a 180km/h dial to a 320km/h dial (I put custom GT-R dials on it with the GTS25t layout) If you have J2 soldered (assuming the S clusters have a similar config to the R clusters); you may need to remove that solder
    • Back on topic 😉, these are some of the notable pages from the booklets that are supplied with each weekly parts update. I never knew the BNR32 test mule car had an S13 Silvia body...
    • This. A 3d wheel alignment is like $120...just take it to the shop. Since theres probably multiple adjustments that need to be made after changing something. Mine has front/rear lower arms, traction rods, tension rods, camber arms, toe arms, front upper arms, hicas kit, sway bars and coilovers. I measure from the edge of the bolt holes on the originals and set the same length on all the adjustable stuff to dial it as close as I could to OEM. Took it straight for alignment; it didnt feel right at all...after alignment, it feels perfect. Similarly i've just changed the springs on another car; and I still needed multiple adjustments to bring it back in spec.
    • A full Veilside kitted JZA80 Supra in Meriken park in Kobe city a few weeks back
×
×
  • Create New...