Jump to content
SAU Community

Recommended Posts

Hi guys and girls.

Whats your plans after the Melbourne cup on Tuesday night?

Come down and celebrate the execution of the infamous Bali Bombers at Bungalow 8 at King St Wharf Sydney.

Meet at 7pm... for a few drinks and a feed to say c'est la vie and celebrate the passing of these evil bastards!

Hope to see you there!

- limecordial

Link to comment
https://www.sau.com.au/forums/topic/242736-bali-bomber-execution-party/
Share on other sites

  • Replies 46
  • Created
  • Last Reply

Top Posters In This Topic

I find the whole concept distasteful to be honest.

I don't see how celebrating someone being killed is any better than the terrorists' mates celebrating their achievements with the bombing. Before you ask, yes I know people who were affected by it.

I don't see how celebrating someone being killed is any better than the terrorists' mates celebrating their achievements with the bombing. Before you ask, yes I know people who were affected by it.

Even if you didn't, the fact that you're not wanting to celebrate the killing of another person, unlike these bombers and their supporters, is a part of what makes you better than them.

They thought they were justified in killing all those people in those night clubs, too.

Guest
This topic is now closed to further replies.



  • Latest Posts

    • Not sure the US can import anything other than the C34 Stagea's, but if you can and you need to to tow, DO NOT under any circumstances get an M35 Stagea. If it is just as a family car and your country/state allows it, absolutely and definitely get an M35 (3.5L if possible as it is effectively a 350Z) over a C34.
    • Punch your VIN (nm35-xxxxxx) into Amayama.com You can see everything there quite easily.
    • Thanks for that, I'll check it all out. I can always do the brakes last anyway if its a problem.  The 16's are super cool, if they do fit I'll cruise around with them for a bit.  
    • Well, that's kinda the point. The calipers might interfere with the inside of the barrels 16" rims are only about 14" inside the barrels, which is ~350mm, and 334mm rotors only leave about 8mm outboard for the caliper before you get to 350, And.... that;s not gunna be enough. If the rims have a larger ID than that, you might sneak it in. I'd be putting a measuring stick inside the wheel and eyeballing the extra required for the caliper outboard of the rotor before committing to bolting it all on.
    • OK, so again it has been a bit of a break but it was around researching what had been done since I didn't have access to Neil's records and not everything is obvious without pulling stuff apart. Happily the guy who assembled the engine had kept reasonable records, so we now know the final spec is: Bottom end: Standard block and crank Ross 86.5mm forgies, 9:1 compression Spool forged rods Standard main bolts Oil pump Spool billet gears in standard housing Aeroflow extended and baffled sump Head Freshly rebuilt standard head with new 80lb valve springs Mild porting/port match Head oil feed restrictor VCT disabled Tighe 805C reground cams (255 duration, 8.93 lift)  Adjustable cam gears on inlet/exhaust Standard head bolts, gasket not confirmed but assumed MLS External 555cc Nismo injectors Z32 AFM Bosch 023 Intank fuel pump Garret 2871 (factory housings and manifold) Hypertune FFP plenum with standard throttle   Time to book in a trip to Unigroup
×
×
  • Create New...